6-Channel Line Output Converter Summing Ÿ AUX Input Ÿ Multi-Function Remote Owner’s Manual www.wavtech-usa.
WARNING CAUTION This symbol means important instructions. Failure to heed them can result in serious injury or death. This symbol means important instructions. Failure to heed them can result in injury or property damages. WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may result in an accident.
Introduction Welcome to Wāvtech, exceptional mobile audio integration products for audiophiles. Our products are engineered to provide a truly remarkable listening experience. Built for the professional installer, our OEM integration and signal processor models are simply the best solution available for unlimited sound system upgrades while retaining the factory receiver.
Top Panel Adjustments Œ AUX Gain Adjustment: Ž This adjustment sets the gain for all output channels from a low level source connected to the AUX input jack. Ž In systems using both the link6's main speaker level inputs and auxiliary input, this gain adjustment is primarily for matching the AUX output level with that of the main source. It is recommended to set the speaker level input gain(s) first, particularly when summing.
Multi-Function Remote Œ Ž Œ Remote Housing: This 2-piece housing design provides both convenient mounting and simple Ž dissasembly for customization. The integrated screw mount tabs are scored to aid removal if securing by another method and the lower housing can be detatched by removing the two top screws for reducing weight or size. For panel mounting, the housing can be completely disassembled by also removing the knob, shaft nut, and circuit board screw.
Installation & System Wiring It is important to read this manual thoroughly before starting your installation and always plan accordingly. Before installing any Wāvtech product, disconnect the negative (ground) wire from the vehicle’s battery to avoid damage to the vehicle or yourself. Following all guidelines will help provide years of enjoyment with your Wāvtech link6 audio interface.
Example-2: Factory Amp + AUX (6-in/4-out or 6-in/6-out) Type-2 Ÿ Main CH5/6 Ÿ AUX Vol Ÿ AUX CH5/6 RLC +12V GND AUX IN REM OUT Optional Front HP CH1/2 IN Front BP Rear Front CH1/2 OUT CH3/4 OUT Sub CH3/4 IN Rear Direct CH5/6 IN CH5/6 OUT Sum or CH5/6 OUT Notes: Ÿ For systems with a main speaker level source that will serve as the master volume control, and an auxiliary source is connected to the link6’s AUX input jack, select system Type-2 at the multi-function remote.
Example-4: Factory Amp w/DSP + AUX (6-in/6-out) Type-4 Ÿ Main Vol Ÿ Main CH5/6 Ÿ AUX Vol Ÿ AUX CH5/6 RLC +12V GND AUX IN REM OUT Front HP Front HP CH1/2 IN CH1/2 OUT Rear HP Rear HP CH3/4 IN CH3/4 OUT Sub LP Sub LP CH5/6 IN CH5/6 OUT Notes: Ÿ For factory amplified systems with more extreme volume dependent DSP effects such as EQ or limiters, or for a standalone system where the source volume will not be accessable after installation, select system Type-4 at the multifunction remote.
Internal Jumper Locations and Settings While all Wāvtech models provide external controls for main adjustments, there are also a few internal configuration jumpers available to resolve certain special vehicle or system conditions. The link6’s internal jumper locations and default settings are shown in the illustration below. To access these jumpers, simply remove the two top screws from each end panel and loosen two bottom screws on one side in order to easily remove the chassis top cover.
Specifications Frequency response Input Impedance Input Sensitivity Max Input Voltage Output Impedance Max Output Voltage THD+N S/N Remote Level Control Turn-On Trigger Remote Output Current Draw Operating Voltage Max Flat (+0/-1dB) Extended (+0/-3dB) Spk Input AUX Input Spk Input (max-min gain) AUX Input (max-min gain) Spk Input peak, <5sec cont.
Warranty & Service Care Wāvtech warrants this product to be free from defects in material and workmanship for a period of one (1) year when purchased from an authorized Wāvtech retailer within the United States. This warranty will be extended to a period of two (2) years when the installation is performed by an authorized Wāvtech retailer. A valid sales receipt is required to verify eligibility of purchase and installation.
v0820 Wāvtech ® 1350 W. Melody Ave. Suite 101 Gilbert, AZ 85233 (480) 454-7017 ©Copyright 2020 Wāvtech, LLC. All Rights Reserved.