Install Guide

www.wavelynxtech.com | 100 Technology Drive, Suite 130B, Broomfield CO, 80021 | 720-572-4963

G-310-0 Fusion Install Guide May 2020, Rev 1.0

WaveLynx Technologies

Edge Reader Installation Guide Rev 1.0

Overview

The Fusion IP Reader is a self-contained RFID Reader and Door Controller. The reader supports 125 kHz,

13.56 MHz, and Bluetooth credentials, while capable of powering up to 500 mA for Door Strike or

Magnetic Lock control.

For In / Out scenarios, the Fusion IP Reader can power and communicate to an external reader through

Open Supervised Device Protocol (OSDP) v 2.1.8.

The device is powered from Power over Ethernet (PoE) and/or a 10VDC – 15 VDC DC Power.

UL Listed when powered using a UL approved DC Power Supply.

Wiring

Install according to ANSI/NFPA70 National Electrical Code and local codes.

All wiring except for the CAT5 Cable shall be shielded wire.

For IP connectivity a Female CAT5 cable comes out the back of the Fusion IP Reader.

Door control and external reader communication utilizes a 10 wire pigtail (note there are two ground

wires):

Red 12 V Out

Black Ground

Brown

Switched

Ground/

+12v Trigger

Orange

12 V In

White RS485B

Green RS485A

Purple AUX

Yellow

DSM

Blue REX

Power In

- DC Power In is rated from 10VDC to 15 VDC. DC Power shall be provided through a UL294 approved

Power Supply with Class 2 limited output.

- Optionally power can be supplied through Power over Ethernet through the RJ45 connector

PAGE 1
WaveLynx Technologies Edge Reader Installation Guide Rev 1.0 Overview The Fusion IP Reader is a self-contained RFID Reader and Door Controller. The reader supports 125 kHz, 13.56 MHz, and Bluetooth credentials, while capable of powering up to 500 mA for Door Strike or Magnetic Lock control. For In / Out scenarios, the Fusion IP Reader can power and communicate to an external reader through Open Supervised Device Protocol (OSDP) v 2.1.8.
PAGE 2
- In the case of both DC power and PoE, the Fusion IP Reader will draw power from the DC power source. Lock Control Magnetic Lock or Door Strike is controlled through the Switched Ground. Switched Ground Switched Ground enables the Ground (powering the lock) or disables ground (releasing power from the lock). Fusion can source up to 500 mA of current through its 12V Out. Connect the positive side of the lock to the 12V Out and Ground wire of the lock to the SW GND of the IP Reader.
PAGE 3
- Mount reader onto wallplate and secure with security screw. Specifications and Troubleshooting General Specifications Power over Ethernet (PoE) and/or 10 – 15VDC. Maximum Input power when powered by a DC power supply is 900 mA 9 VDC – 15VDC based on DC Power Supply - 12 VDC when powered by PoE. Sourcing up to 700 mA.