User's Manual

5
––
Max Length to Panel
Length
AWG
200’ (60 m)
22
300’
20
500’
18
Common
Cable Connections
Red
Power In
Black
Ground
Shield
Shield Ground
Brown*
Tamper Out
Green
Wiegand Data 0 / RS
-
485A
White
Wiegand
Data 1 / RS
-
485B
Yellow*
Beeper Control
Blue*
Green LED Control
Orange*
Red LED Control
Current @ 12 V
Avg. mA
Max. mA
100
160
Install the Reader Screw
Install the #4-40 screw or pin-in-torx at the bottom of the
reader.
Test the Reader
Power the reader, the red light-bar will light, followed by a
beep. Present a valid credential to the reader and the
light-bar will turn green.
Attach the Reader to the
Wall Plate
Align the reader so that the tabs of the base plate slide into
the slots on the wall plate and slide the reader into position.
Wall Mount
ed
Reader Installation
This installation guide applies to the ET10 Mullion Reader.
Included:
• (2) #6 Screws
• Reader, Backplate, and Wall Plate
• (1) #4-40, (1) pin-in-torx
The Following tools are needed to install a mullion reader:
• Phillips Screwdriver
• 6-32 Tap (if installing on metal)
• 1/2” drill bit
•
T8
Security Torx Bit (
optional for increased tamper detection)
Mounting Holes for
Wall Plate
Drill two mounting holes at a minimum of 1.7” apart. Drill a
½” hole in the center for the pigtail wire to pass through.
Use the wall plate as a guide for drilling.
3
Wire the
C
able to the
C
ontrol
Panel
*these wires are only used in
Wiegand readers.
4
6
1
2
Install Metal
Wall Plate
Once the holes are prepared, screw the wall plate in using
the provided #6 screws.
Mounti
ng hole
distance is
adjustable, use
the provided
#
6
screws
½”
Hole for
Pigtail
Screw or
pin-in-
torx
Contact Us
WaveLynx Technologies
[phone]
www.wavelynxtech.com
*Patent Pending
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Wavelynx could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.