WaveIP Ltd. GigAccess™ OFDM 700 RSU GigAccess™ OFDM 700 RSU Installation and Operation Instructions January 2006 The information contained in this document is of commercial value, proprietary to WaveIP. It is conveyed to the recipient solely for the purpose of evaluation. Reproduction of this document, disclosure of its contents or any other use of the information herein is strictly forbidden unless expressly authorized in writing by WaveIP. WaveIP Ltd. P.O.
WaveIP Ltd. GigAccess™ OFDM 700 RSU TABLE OF CONTENTS 1. 1.1 1.2 2. INTRODUCTION..................................................................................... 4 GENERAL .................................................................................................4 GIGACCESS™ OFDM SYSTEM OVERVIEW ..........................................................4 INSTALLATION ...................................................................................... 5 2.1 PACKING LIST ......................
WaveIP Ltd. GigAccess™ OFDM 700 RSU 1. Introduction 1.1 General This document describes how to install and use GigAccess™ OFDM 700 Residential Subscriber Unit (RSU) to obtain wireless high-speed Internet access. 1.2 GigAccess™ OFDM System Overview GigAccess™ OFDM is a wireless point-to-point and point-to-multipoint broadband communication system. The basic subsystem is composed of a single sector, which consists of an Access Unit (AU) and up to 250 Subscriber Units (SU).
WaveIP Ltd. GigAccess™ OFDM 700 RSU 2. Installation 2.1 Packing List When you first open the package, verify that the unit is complete with the following components: 1. RSU Unit 2. Indoor Power Supply (AC input). 3. Quick start guide.
WaveIP Ltd. GigAccess™ OFDM 700 RSU 2.2 Installation Procedure 2.2.1 General The RSU is a self-installed, plug and play unit, which requires minimum operation from the user. A description of the RSU is given in the figure below. 1. Polarization Indication 2. Air link led (Green) 3. ETH link led (Yellow) 4. Received Signal Indicator Lights 5. ETH Connector 6. Power led 7. DC Power Jack 4 3 2 5 1 6 7 Figure 2-2: GigAccess™ OFDM Self-install RSU 2.2.
WaveIP Ltd. GigAccess™ OFDM 700 RSU • Obtain a clear line of site to the AU as much as possible - avoid any physical obstacles, which may block the signal. 2.2.3 Installation The installation process should follow the following steps: 1) Connect the CAT5 Ethernet cable from the RSU data port to your PC NIC. Note that your RSU consists two Ethernet ports, so you can connect your PC to either of them, or to connect two PCs; each PC to different Ethernet connector.
WaveIP Ltd. GigAccess™ OFDM 700 RSU AU Direction RSU Power Supply 100-240V AC Ethernet Data Cable CAT5 Figure 2-3: GigAccess™ RSU - Installation Scheme 2.2.4 Radio Channel Selection The radio channel is defined at the AU side. The RSU is pre-configured to scan all channels. Therefore it will acquire the AU channel automatically. 2.2.5 User PC Setup In Case of specific IP setup – configuration the PC IP as followed: • Press right click on the Network Neighborhood Icon.
WaveIP Ltd. GigAccess™ OFDM 700 RSU 2.3 FCC Information Notice: This device has been tested and found to comply with Radio Frequency Exposure Limits. A minimum separation distance of 20 cm must be maintained between the device in operation and all persons. This device complies with Part 15 of the FCC Rules.
WaveIP Ltd. GigAccess™ OFDM 700 RSU 3. GigAccess™ OFDM 700 RSU Technical Specifications 3.1 General Specification Access technology TDMA (Time division multiple access) Duplex schemes TDD (Time division duplex) Wireless MAC Interface Proprietary based on IEEE 802.16 Applications Access, Campus, Consecutive 3.