GigAccessTM 2.
December 2003 Rev. A Table of Contents 1. INTRODUCTION........................................................................................................... 3 1.1. GENERAL ................................................................................................................................................3 TM 1.2. GIGACCESS SYSTEM OVERVIEW .........................................................................................................3 2. PACKING LIST...............................
December 2003 Rev. A 1. Introduction 1.1. General Congratulations on your purchase of the WaveIP GigAccess™ self-install Business/Residential Subscriber Unit (BSU/RSU). This document describes how to install and use your subscriber unit to obtain wireless high-speed Internet access. You can connect your RSU both to a computer and to a local area network (LAN) through the integrated two ports. 1.2.
December 2003 Rev. A 2. Packing List When you first open the package, verify that the unit is complete and consists: • BSU or RSU • Power Supply • Quick Start Guide BSU Part number: BSU-24D-115D-FU. RSU Part number: RSU-24D-115D-FU. Figure 2-1 illustrates the RSU package contents. GiAccessTM Self-Install BSU/RSU User Guide Quick Start Guide PRELIMINARY Rev A Figure 2-1: BSU/RSU package contents 3. Installation Process 3.1.
December 2003 Rev. A Polarization Indication ETH Connector DC Power Jack Received Power Indication Leds Power led (green) Air link led (Green) ETH link led (Yellow) Figure 3-1: General Description for GigAccess™ 2.4 Self Install BSU/RSU 3.2. Before You Start 1) Make sure your computer is equipped with an Ethernet Network Interface (NIC) 2) Make sure your computer is set up to automatically obtain an IP address (See 3.5).
December 2003 Rev. A preferred orientation is vertical polarization. (Above ground propagation of the signal is better when it is polarized vertically). 4) The BSU/RSU will automatically acquire the radio channel of the AU. • Verify that the Air link led flashes (green led on the Ethernet connector), which indicated reception from the AU. • Verify that the Ethernet link led light (yellow led on the Ethernet connector) when the PC is connected.
December 2003 Rev. A 3.6. Safety 1. Do not immerse the equipment in any type of liquid. 2. Only operate the BSU/RSU with the supplied Power Supply! Any other type of input power source may cause damage and voids the warranty. 3. Do not place the equipment on an unstable surface. 4. Do not disassemble the equipment. Removing covers voids the warranty. 5. Do not expose the equipment to extreme hot or cold temperatures. 3.7.
December 2003 Rev. A 4. GigAccessTM 2.4 BSU/RSU Technical Specifications Operating Frequency 2.412 – 2.462 GHz ISM band (CH1 - CH11) Number of Channels 11 Access technology TDMA (Time division multiple access) Duplexing schemes TDD (Time division duplex) RF Waveform Direct Sequence Spread spectrum (DSSS) Modulation DQPSK, 16CCK , 256 CCK Raw Data Rates 5.5 Mbps and 11 Mbps Data Throughput Up to 8.5 Mbps for BSU 1 Up to 2.
December 2003 Rev. A 5. FCC Declaration of Conformity We, the undersigned, Company: WaveIp Inc. Address: 4101 East Lake Estates DR. Davie FL 33328 Country: USA Telephone number: 954-4527-580, 954-9938-335 (Mobile) Fax number: 305-3746-538 are the Responsible Party for this Declaration, certify and declare under our sole responsibility that the following equipment: Brand WaveIP Product description Type GigAccess 2.
