User's Manual

ManualsBrandsWatt Stopper ManualsElectronicsWIRELESS 2000 WATT COMMERCIAL DIMMER

REV DESCRIPTION INT: REV. DATE APPROVED

1 ECO# CO1556 MJS 10/9/06 CG

2 ECO# C01973 MJS

TITLE BOX PAGE ONLY.

DO NOT MAKE FILM • DO NOT PRINT THIS PAGE

MATERIAL: White 16lb (60g/m sq)

Ink: Black

Print Two Sides

Final Trim Size: 8.5” (Wide) x 11” (High)

IF YOU HAVE ANY QUESTIONS REGARDING

SPECIFICATIONS OR REQUIRE ADDITIONAL FILE

FORMATTING, PLEASE CONTACT Mary Jo Sowinski.

Phone: 408-486-7511

Email: maryjo.sowinski@wattstopper.com

All information in this drawing is the property of Watt

Stopper/Legrand and cannot be copied or used without the

written approval of Watt Stopper/Legrand.

Title: MR2000 Installation Instructions

SANTA CLARA, CALIFORNIA

DRAWN BY

PLM

ENG

MARCOM

SOWINSKI

SCALE 1:1

Drawing #:

06145

Orig. Drawing Date: 6 OCT 06

Revision Date: 10 OCT 06

REV.#:

Summary of content (5 pages)

PAGE 1
REV DESCRIPTION 1 ECO# CO1556 2 ECO# C01973 INT: MJS MJS REV. DATE APPROVED 10/9/06 CG TITLE BOX PAGE ONLY. DO NOT MAKE FILM • DO NOT PRINT THIS PAGE MATERIAL: White 16lb (60g/m sq) Ink: Black Print Two Sides Final Trim Size: 8.5” (Wide) x 11” (High) IF YOU HAVE ANY QUESTIONS REGARDING SPECIFICATIONS OR REQUIRE ADDITIONAL FILE FORMATTING, PLEASE CONTACT Mary Jo Sowinski. Phone: 408-486-7511 Email: maryjo.sowinski@wattstopper.
PAGE 2
MR2000 Universal Dimmer SPECIFICATIONS DESCRIPTION phase control dimmer with a normally open air-gap relay at the load output. It provides 120/277VAC, phase to neutral input to the load. Top Dog™ Wireless Communication Watt Stopper wireless devices use radio signals to communicate with each other to control lighting and other types of electric loads in selected areas. These wireless devices use the 900MHz band for high-speed control communication.
PAGE 3
WIRING INSTRUCTIONS INSTALLATION 1. The unit must be installed in compliance with the Environment and Orientation instructions. 2. 3. 4. 5. 6. Disconnect power to the circuit by turning the circuit breaker OFF before installation. WARNING CAUTION TURN THE POWER OFF AT THE CIRCUIT BREAKER BEFORE INSTALLING THE DIMMER. Disconnect power when servicing fixture or changing lamps. Both lighting fixture and dimmer must be grounded. Use this device only with copper wire. Strip existing wire ½” (12.7mm).
PAGE 4
FLUORESCENT SETUP ADVANCED OPERATION FOR WIRELESS If the dimmer will operate 2-wire fluorescent or compact fluorescent loads, a special configuration step is required. Application Assistance for wireless 1. 2. 3. 4. Press and hold until the LED ﬂashes yellow (about 2 seconds). Press the top of the device paddle until the LED brieﬂy ﬂashes red. Press and hold until the LED changes to green (about 2 seconds.
PAGE 5
CLEANING & MAINTENANCE OPERATIONS FCC NOTICE Clean only using a cloth dampened with water and a little mild detergent. Use of solvents or hydrocarbon-based cleaners may cause permanent damage. FCC ID: Q4BMR2K Replacing Lamps When a lamp must be replaced, disconnect power. Power Fail Memory After a power failure, all wireless devices automatically return to the state that they were in immediately prior to loss of power. All configuration and scene control information is preserved.