wGravity Smart lock Installation Manual
BOX CONTENTS ✓ Lock ✓ Receiver ✓ Installation pieces ✓ 4 AA batteries 1.5 volt ✓ Screws ✓ Instructions DOWNLOAD YOUR APP After downloading the App, sign up as a user. Read product QR that is on the back of the wGravity or on the battery cover.
INSTALLATION TIPS Make sure that the door frame is at least 7 centimeters wide and choose the height you wish to install the wGravity
Tools required: PZ2 star screwdriver We recommend the use of an electric screwdriver. INSTALLATION INSTRUCTIONS NOTE: To change the batteries of the wGravity more conveniently, it is recommended to remove the lid of the closure to better access the battery housing.
Wall 1 Check the difference in height on the outside of the flap and the door to correctly use the given spacers. Placket 2 Place the base of the wGravity at the desired height and flush with the edge of the door.
3 Anchor the base with the wGravity with the upper and lower straight slot. Do not squeeze too much to allow movement of the base. 4 Using the straight grooves finish adjusting the base to the door.
5 Tighten the five screws of the base. 02 02 02 6 Place positioner in the base.
7 Fit the Receiver on top of the Positioner. 8 Fix the receiver, together with the necessary spacers.
Once the receiver is installed, you can remove the positioner from the base. 10 Place the cover trim with its two corresponding screws.
11 Fit the lock on the base placed on the door. 12 Screw the lock to the base.