Installation and Operating Instructions

Important Safety Information
To make the most of this radio, it must be used properly.
Please read the installation and operating instructions carefully before using the radio. Special
attention must be paid to the WARNING and NOTICE statements in this manual.
Note:
This radio complieswith IEEE and ICNIRP exposure limits for General Population/Uncontrolled
Environments RF exposure emvironment at operating duty factors of up to 50% and is authorized by
the FCC for General Population use only. An appropriate warning lable is affixed to all units. In order to
comply with RF exposure requirements, a minimum distance of 2.5 cm must be maintained when
held-to-face, and body-worn operations are restricted to the approved original acessories (belt
clip), a minimum distance of 0 cm. Do not use this device when antenna shows obvious damages.
FCC Statement:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this
device does not cause harmful interference.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates and can radiate radio
frequency energy. If not installed and used in accordance with the instructions, it may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. Verification of harmful interference by this equipment to radio or television
reception can be determined by turning it off and then on. The user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING:
MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS
PROHIBIITED UNDER FCC RULES AND FEDERRAL LAW.
Y

Summary of content (1 pages)