Installation Manual

© 2010 Wm. K. Walthers, Inc.
Milwaukee WI, 53218
HO Scale
Structure Kit
933-3331
FIELDSTONE BARN BASE & RAMP
Thank you for purchasing this kit. Tools to help
you with assembly include a #11 knife, rough file,
finish file, 100 grit sandpaper, small square, ACC
(super-glue) and dust mask.
After sanding and assembling the base, apply
primer and finish colors.
Barn walls will rest on
outside of lip of base.
Ends of short walls fit inside longer walls to
form corners.
NOTE: We suggest wearing a dust mask and
working in a well ventilated area when sanding.
NOTE: If adding to Meadowhead Barn (933-
3330, sold separately) or Sparrow Creek Barn
(933-3341, sold separately), test fit to barn
model and adjust fit as needed.
90°
90°
Glue walls together. Walls should be 90° (right
angle) to each other and plumb vertically when
gluing.
Sand both ends of shorter (end)
walls until square. These walls
should be the same length when
finished.
Sand
After painting, Meadowhead Barn (933-3330,
sold separately) or Sparrow Creek Barn (933-
3341, sold separately) may be fit onto barn base,
if desired.
Press back of walls onto 100 grit sandpaper.
Sand each piece until the back is smooth and
window openings are free of material. Make
sure sandpaper is on a flat, smooth surface.
Back of ramp should be filed or sanded for
a tight fit against wall. Remove material as
needed from wall to minimize exposed gap
where ramp and wall meet.
Glue ramp to wall, aligning it with the barn
door location.
Step 1 Step 2
Step 5
Step 4Step 3