Supplied Par ts List (1)Wall Plate (2)Monitor Bracket (1)Bubble Level-a (1)Allen Key-b (4)M4 Spacer-c (8)M6/M8 Spacer-d (4)M4 Washer-e (4)M6 Washer-f (4)M8 Washer-g (4)M4x12 Bolt-h (4)M4x30 Bolt-i (4)M6x20 Bolt-j (4)M6x35 Bolt-k (4)M8x20 Bolt-l (4)M8x35 Bolt-m (4)M8x50 Bolt-n (4)Bolt Cover-o (4)Lag Bolt Washer-p (4)Lag Bolt-q (4)Concrete Anchor-r Tools Required 4mm Drill Bit Phillips Screwdriver 10mm Masonry Bit Carpenter's Level Note: The mounting components and hardware supplied in
Mounting the Wall Plate to the Wall Step 1 Wood Studs Wall p q o 65mm 4mm Attention: Please don’t install upside down. Brick or Concrete Wall o q p r 65mm 60mm 10mm Attention: Please don’t install upside down. CAUTION! ! WARNING This TV mount must be securely attached to the vertical wall. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.
Step 2 Mounting the Monitor Brackets to a TV First of all, make sure the diameter of the Bolt(h to n) your TV requires. Once you have determined the correct diameter, please see the diagram as below. You will thread the Bolt into the TV using the correct Washer(e,f,g), and using the spacer(c,d) if necessary. Please make sure the Monitor Brackets are vertically centered and level with each other.
Step 4 Level the TV Mount Loosen four bolts by maximum ONE 360 degree turn as below diagram, then adjust the level of the TV, finally fasten the bolts by supplied Allen Key(b). WARNING: Don’t over loose the bolts to provent the TV from falling off! b Step 5 Adjusting the Tilting Angle Adjust the TV to the desired angle and fasten the two bolts by the supplier Allen Key(b) as below diagram.
This mount can be separated into two parts and used as two mounts as below. Romve the four bolts by provided Allen key(b) to disconnect the front larger plate and VESA 100 plate.
Part 1 can be used for TV with VESA 100x100mm mounting holes Install the wall plate as the Step 1 on page 3, then connect the TV to plate by 4pcs M4 Bolts(h,i) and 4pcs M4 Washer(e). Use the M4 Spacer(c) if necessary. e h,i Part 2 can be used for TV with Max VESA 400x400mm mounting holes Part 2 Step 1A: Mounting the Wall Plate to the Wood Studs Wall 16"( Wood Studs Wall You may need to purchase extra lag bolts and concrete anchors according to your actual condition.
Part 2 can be used for TV with Max VESA 400x400mm mounting holes Part 2 Step 1B: Mounting the Wall Plate to the Brick or Concrete Wall Brick or Concrete Wall You may need to purchase extra lag bolts and concrete anchors according to your actual condition. q r p 65mm 60mm 10mm Part 2 Step 2: See Step 2 on page 4. Part 2 Step 3: Attaching TV to Wall Plate and Adding the Safety Bolts Warning: Some TVs may require two people to lift! We are not responsible for personal injury or product damage.