User's Manual

User Manual

WakeCap Asset

WakeCap Technologies, Inc

500 Westover Dr #11679 Sanford NC 27330 United State

Trademarks

Any trademarks, trade names, service marks or service names owned or registered by any other

company and used in this document are the property of its respective company.

Document information

Author: Hemal Chevli

Revision History:

Date

Description

18-Dec-19

First Draft.

Device Specifications

Dimensions: 43 mm x 43mm x 43mm

Weight: 35g

Battery Type: 1000mAH Lithium Manganese Dioxide with reverse polarity protection.

Battery Life: 1 year in typical use case.

Motion Sensor: 3-axis accelerometer.

Environmental Sensor: Temperature, barometer, humidity.

Radio Frequency: 2.4GHz ISM band.

Operating Temperature: -20 to -60 deg C

Protection: IP67, UV resistant.

Operation Description:

In normal operation when power is applied to the board by 3V Cr2477 coin cell, the stack initializes

and based on its configuration it searches for neighbours and sends sensor data for processing to the

gateway device via the mesh network. There is no external ground connection, the ground is only

that of the printed circuit board. The current is supplied by the CR2477 coin cell. The frequency is

divided the band into 40 channels with bandwidth of 1MHz each and channel spacing of 2MHz.

PAGE 1
User Manual WakeCap Asset WakeCap Technologies, Inc 500 Westover Dr #11679 Sanford NC 27330 United State Copyright All rights reserved. WakeCap Technologies, Inc 2018-2019 Trademarks Any trademarks, trade names, service marks or service names owned or registered by any other company and used in this document are the property of its respective company. Document information Author: Hemal Chevli Revision History: Date 18-Dec-19 Description First Draft.
PAGE 2
Frequency range: 2402-2480MHz Modulation type: GFSK. Crystals used on board: 32MHz Getting started The Asset is sealed device that is IP67 protected and there is a push button in the middle of the flexible orange rubber. Each device can be configured using NFC. The device will automatically join the network based on the configuration set. Next attach the asset device to the hard hat as shown in the picture. On the app assign the hard hat to a worker.
PAGE 3
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)this device must accept any Interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.