User's Manual

User Manual

WakeCap Anchor

WakeCap Technologies, Inc

500 Westover Dr #11679 Sanford NC 27330 United State

Trademarks

Any trademarks, trade names, service marks or service names owned or registered by any

other company and used in this document are the property of its respective company.

Document information

Author: Hemal Chevli

Revision History:

Date

Description

18-Dec-19

First Draft.

Device Specifications

Dimensions: 43 mm x 43mm x 43mm

Weight: 35g

Battery Type: 15 AH Alkaline battery with reverse polarity protection.

Battery Life: 3 years in typical use case.

Motion Sensor: 3-axis accelerometer.

Environmental Sensor: Temperature, barometer, humidity.

Radio Frequency: 2.4GHz ISM band.

Operating Temperature: -20 to -60 deg C

Protection: IP67, UV resistant.

Operation Description:

WakeCap Anchor uses highly integrated Nordic nRF52832 SoC. This chip includes all the

radio components including the antenna port and the 32-bit microcontroller to run the stack.

In normal operation when power is applied to the board by two D-size alkaline batteries, the

stack initializes and based on its configuration it searches for neighbours and sends sensor

data for processing to the gateway device via the mesh network. There is no external

PAGE 1
User Manual WakeCap Anchor WakeCap Technologies, Inc 500 Westover Dr #11679 Sanford NC 27330 United State Copyright All rights reserved. WakeCap Technologies, Inc 2018-2019 Trademarks Any trademarks, trade names, service marks or service names owned or registered by any other company and used in this document are the property of its respective company. Document information Author: Hemal Chevli Revision History: Date 18-Dec-19 Description First Draft.
PAGE 2
ground connection, the ground is only that of the printed circuit board. The current is supplied by two 1.5V primary cell in series. The Mesh divided the band into 40 channels with bandwidth of 1MHz each and channel spacing of 2MHz. The antenna is SMA pig tail type connected via Hirose U.FL connector to the board. Frequency range: 2402-2480MHz Modulation type: GFSK. Crystals used on board: 32MHz Mounting: Screwed on the wall or optional pole mount kit.
PAGE 3
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)this device must accept any Interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.