Datasheet

585
10
10
WAGO Communication Cable
The WAGO communication cable offers a simple solution for communicating
with the WAGO software tools (e.g., WAGO-I/O-CHECK, WAGO-I/O-PRO)
NOTICE: The communication cable must not be connected or removed
when the system is energized.
The WAGO USB Service Cable connects a PC (notebook) to either the service
Interface of the 857 Series Signal Conditioners and Relay Modules
(JUMPFLEX) or to WAGO-I/O-SYSTEM buscouplers/controllers.
Notice:
Using the WAGO 759-923 USB Service Cable in combination with some of
the programmable fieldbus controllers requires a certain firmware version or
higher:
750-841 as from firmware version 12
750-872/0020-0000 as from firmware version 2
Description
Item No.
Pack.
Unit
Communication cable (used to register or
remove the end extension module) 750-920 10
Technical Data
Ports 4-pole service connectors
Length 2.5 m
Operating temperature 0°C ... +55°C
Degree of protection IP20
Weight 70 g
Connector dimensions (WxHxD) 15 x 50 x 19 mm
Description
Item No.
Pack.
Unit
WAGO USB Communication Cable,
length 2.5 m 750-923 1
WAGO USB Communication Cable,
length 5 m 750-923/000-001 1
Technical Data
USB specification 2.0 compatible/full-speed device
Operating system Microsoft
®
Windows
®
2000;
Microsoft
®
Windows
®
XP Professional;
Microsoft
®
Windows
®
Vista
®
;
Microsoft
®
Windows
®
7
Operating temperature -25 °C ... +70 °C
Interface USB Type A/m
Length 2.5 m (750-923)
5 m (750-923/000-001)
Connector dimensions (WxHxD)
15 x 50 x 19
Test voltage 2.5 kV, 50 Hz, 1 min.
EMC: 1 - immunity to interference acc. to EN 61000-4-3, EN 61000-4-6
EMC: 1 - emission of interference acc. to EN 55022
Approvals
Conformity marking 1
WAGO Kontakttechnik GmbH & Co. KG
Subject to design changes 18.05.2012
Postfach 2880 - D-32385 Minden
Hansastr. 27 - D-32423 Minden
Phone: [phone] E-Mail: [e-mail]
Fax: [phone] www.wago.com