ASSEMBLY INSTURTIONS EASY 1/8 DIFFICULT
/8
/8
/8
COUNTER HEIGHT CHAIR PARTS #1 1pc #2 1pc #3 1pc #4 1pc Backrest w/Legs Seat Right Front Leg Left Front Leg #5 1pc #6 1pc #7 1pc Front Leg Support Right Leg Support Left Leg Support HARDWARE #A 2pcs #B 4pcs #C 4pcs #D 10pcs Bolt ∅ 5/16" x 1-3/4" Bolt ∅ 5/16" x 2" #F 1pc Bolt ∅ 5/16" x 3-1/4" #G 1pc Flat Washer ∅ 5/16" Lock Washer ∅ 5/16" Allen Wrench Wood Dowel Wood Screw #E 10pcs 5/8 #H 6pcs
Insert the front leg support (#5) into the right front leg (#3) and the left front leg (#4). 1 Part Part Part #3 #5 #4 Note: Right and left are determined by facing the front of the chair in the upright position. 2 Part Part Part Part Hardware Hardware #5 Hardware Hardware I. Place the seat (#2) facing down on a protected surface. Insert a wood dowel (#G) into the center hole of the seat (#2). II. Align the assembled front legs with the pre-drilled holes of the seat (#2). III.
3 Part Part Part Hardware Hardware Hardware I. Insert the right leg support (#6) into the right front leg (#3) and insert the left leg support (#7) into the left front leg (#4). II. Align the backrest with legs (#1) with the wood dowel (#G) and the other ends of the leg supports. III. Prepare 2 bolt assemblies by inserting FIRST the lock washer (#E) onto the bolt (#A) and then the flat washer (#D) onto the SAME bolt (#A), in that order. IV.
5 Turn right (clockwise) to tighten Hardware #4 #5 #7 Secure all the leg supports with 6 wood screws (#H) using a Phillips screwdriver to lock them with the backrest with legs (#1), the right front leg (#3) and the left front leg (#4). #2 #1 6 Carefully place the completed chair in the upright position. Make sure the chair is rested on a flat surface and does not feel loose or wobbly. If it does, double check that the bolts/screws are secured and properly tightened.