User's Manual

Quick start guide
DM1212
DM1212-2
Audio Baby Monitor
Go to www.vtechphones.com
to register your product for enhanced
warranty support and the latest VTech
product news.
Frequency control Crystal controlled PLL synthesizer
Transmit frequency Baby unit: 1921.536-1928.448 MHz
Parent unit: 1921.536-1928.448 MHz
Channels 5
LCD 35 (x) x 21.2 (y) mm B&W LCD
Nominal effective range Maximum power allowed by FCC and IC. Actual operating range may vary
according to environmental conditions at the time of use.
Power requirement Parent unit: 2.4 V Ni-MH battery
Baby unit power adapter:
Output: 6V DC 400mA
Parent unit power adapter:
Output: 6V DC 400mA
Technical specifications
Specifications are subject to change without notice.
© 2020 VTech Communications, Inc.
All rights reserved. 01/20. DM1212-X_QSG_V1
Document order number: 96-012974-010-100
When using your equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock
and injury, including the following:
1. Follow all warnings and instructions marked on the product.
2. Adult setup is required.
3. This product is not a substitute for adult supervision of the infant. Supervising the infant is the parent’s or caregiver’s
responsibility. This product could cease operating, and therefore you should not assume it will continue working properly
for any given period of time. Further, this is not a medical device and should not be used as such. This product is intended to
assist you in supervising your baby.
4. Do not use this product near water. For example, do not use it next to a bath tub, wash bowl, kitchen sink, laundry tub
or swimming pool, or in a wet basement or shower.
5. CAUTION: Use only the batteries indicated in this manual. There may be a risk of explosion if a wrong type of battery is
used for the parent unit. Use only the supplied rechargeable battery or replacement battery pack (BT166342/BT266342)
for the parent unit. Do not dispose of batteries in a fire. They may explode. Dispose of used battery according to the
information in The RBRC
®
seal.
6. Use only the adapters included with this product. Incorrect adapter polarity or voltage can seriously damage the product.
Baby unit power adapter: Output: 6V DC 400mA;
Parent unit power adapter: Output: 6V DC 400mA.
7. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
8. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.
9. Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
10. Unplug the power cords before replacing batteries.
11. Do not cut off the power adapters to replace them with other plugs, as this causes a hazardous situation.
12. Do not allow anything to rest on the power cords. Do not install this product where the cords may be walked on or
crimped.
13. This product should be operated only from the type of power source indicated on the marking label. If you are not
sure of the type of power supply in your home, consult your dealer or local power company.
14. Do not overload wall outlets or use an extension cord.
15. Do not place this product on an unstable table, shelf, stand or other unstable surfaces.
16. This product should not be placed in any area where proper ventilation is not provided. Slots and openings in the back
or bottom of this product are provided for ventilation. To protect them from overheating, these openings must not be
blocked by placing the product on a soft surface such as a bed, sofa or rug. This product should never be placed near
or over a radiator or heat register.
17. Never push objects of any kind into this product through the slots because they may touch dangerous voltage points
or create a short circuit. Never spill liquid of any kind on the product.
18. To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility.
Opening or removing parts of the product other than specified access doors may expose you to dangerous voltages
or other risks. Incorrect reassembling can cause electric shock when the product is subsequently used.
19. You should test the sound reception every time you turn on the units or move one of the components.
20. Periodically examine all components for damage.
21. Be aware of possible loss of privacy while using public airwaves. Conversations may be picked up by other nursery
monitors, cordless phones, scanners, etc.
22. Children should be supervised to ensure that they do not play with the product.
23. The product is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
SAVE THESE INSTRUCTIONS
Cautions
1. Use and store the product at a temperature between 32
o
F and 104
o
F.
2. Do not expose the product to extreme cold, heat or direct sunlight. Do not put the product close to a heating source.
3. Batteries should not be exposed to excessive heat such as bright sunshine or fire.
4. Warning—Strangulation Hazard—Children have STRANGLED in cords. Keep this cord out of the
reach of children (more than 3 ft (0.9 m) away). Do not remove this tag.
5. Never place the baby unit inside the baby’s crib or playpen. Never cover the baby unit or parent unit
with anything such as a towel or a blanket.
6. Other electronic products may cause interference with your baby monitor. Try installing your baby
monitor as far away from these electronic devices as possible: wireless routers, radios, cellular
telephones, intercoms, room monitors, televisions, personal computers, kitchen appliances and cordless telephones.
Precautions for users of implanted cardiac pacemakers
Cardiac pacemakers (applies only to digital cordless devices):
Wireless Technology Research, LLC (WTR), an independent research entity, led a multidisciplinary evaluation of the
interference between portable wireless devices and implanted cardiac pacemakers. Supported by the U.S. Food and Drug
Administration, WTR recommends to physicians that:
Pacemaker patients
Should keep wireless devices at least six inches from the pacemaker.
Should NOT place wireless devices directly over the pacemaker, such as in a breast pocket, when it is turned ON.
WTR’s evaluation did not identify any risk to bystanders with pacemakers from other persons using wireless devices.
Electromagnetic fields (EMF)
This VTech product complies with all standards regarding electromagnetic fields (EMF). If handled properly and according
to the instructions in this user’s manual, the product is safe to be used based on scientific evidence available today.
Important safety instructions
Power on or off the baby monitor
Press to power on the baby unit. The power light turns on.
Press and hold to power off the baby unit. The power light turns off.
Press and hold to power on or off the parent unit.
Positioning the baby monitor
> 3ft (1m)
Caution
The default volume of your parent unit
is level 3. If you experience high-pitched
screeching noise from your baby monitor
while positioning:
- Make sure your baby unit and parent unit
are more than 6.5 feet (2 meters) apart, OR
- Turn down the volume of your parent unit.
>
6.5ft (2m)
<
6.5ft (2m)
<
3ft (1m)
3ft (1m)
﹏﹏﹏
﹏﹏﹏
﹏﹏﹏﹏
﹏﹏﹏﹏
﹏﹏﹏﹏
﹏﹏﹏﹏﹏
﹏﹏﹏﹏﹏
﹏﹏﹏﹏﹏
﹏﹏﹏
﹏﹏﹏
﹏﹏﹏﹏
﹏﹏﹏﹏
﹏﹏﹏﹏
﹏﹏﹏﹏﹏
﹏﹏﹏﹏﹏
﹏﹏﹏﹏﹏
Basic operation
NOTESNOTE
Note
To avoid interference from other
electronic devices, place your baby
monitor at least 3 feet (1 meter)
away from devices such as wireless routers,
microwaves, cell phones and computers.
>
6.5ft (2m)
LINKED
LINKED
Caution
For hearing protection, make sure the
parent unit is more than 6.5 feet (2 meters)
away from the baby unit. If you hear any
high-pitched noise, move the parent unit
further until the noise stops. You can also
press on the parent unit to lower or
mute the noise.
Adjust speaker volume
Press / to adjust your parent unit speaker
volume.
Talk to your baby unit
Press and hold TALK and speak to your
parent unit. Your voice is transmitted to
the baby unit. Release TALK when finish
talking and hear your baby again.
Press and hold
What’s in the box
Quick start guide
NOTESNOTE
Use only the battery supplied with this product.
If the parent unit will not be used for a long time, disconnect and remove the battery to prevent
possible leakage.
1 set for DM1212
2 sets for DM1212-2
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT166342/BT266342 (2.4V 750mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1937
Connect and charge the battery
Install the parent unit battery
1
2
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT166342/BT266342 (2.4V 750mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1937
THIS SIDE UP
3
4
1
2
3
4
Connect and charge the battery
Connect the baby monitor
NOTESNOTE
Use only the power adapters supplied with this product.
Make sure the baby monitor is not connected to a switch-controlled electric outlet.
Connect the power adapters in a vertical or floor mount position only. The adapters’ prongs
are not designed to hold the weight of baby monitor, so do not connect them to any ceiling,
under-the-table, or cabinet outlets. Otherwise, the adapters may not properly connect to the
outlets.
Make sure the parent unit, the baby unit and the power adapter cords are out of reach of
children.
With audio reminder feature preset to ON, the parent unit plays an audio reminder when
it is connected to a baby unit.
1
2
1
2
Baby unit overview
8
9
10
11
12
1
7
2
3
6
5
8
9
10
11
4
12
1 Projector ball
2
Microphone
3 PAGE
Press to start or stop paging parent unit.
4
Press to turn the night light on or off.
5
(On/off)
Press to power on, and the power light
turns on.
Press and hold to power off, and the
power light turns off.
6 Power light
On when the baby unit is turned on.
7 Projection on/off
Press to turn the projection on or off.
8
Night light
On when night light is turned on
manually.
Off when night light is turned off
manually.
9 Speaker
10
Press to increase the speaker volume.
11
Press to decrease the speaker volume.
12 Power jack
Get help with the online topics
For operations and guides to help you using your video monitor, and for latest
information and supports, go and check the online help topics and online FAQs.
Use your smartphone or mobile device to access our online help.
Go to https://help.vtechphones.com/dm1212; OR
Scan the QR code on the right. Launch the camera app or QR code scanner app
on your smartphone or tablet. Hold the device’s camera up to the QR code and
frame it. Tap the notification to trigger the redirection of the
online help.
- If the QR code is not clearly displayed, adjust your camera’s focus by moving
your device closer or further away until it is clear.
S
m
Turn on the nightlight
Press to turn on the night light.
Turn on vibration alert
is shown on LCD display once this
feature is on.
2
3
1
1

Summary of content (2 pages)