User's Manual

User’s manual
VM314
Accessory baby unit
for use with VTech model
VM344
Congratulations
on purchasing your new VTech product. Before
using this product, please read Important
safety instructions.
This manual has instructions on how to set
up and pair your new baby unit. For complete
instructions on using the baby unit, see the
user’s manual that comes with your video and
audio monitor.
For support, shopping, and everything new at
VTech, visit our website at
www.vtechphones.com.
Register online to get an additional
3-month warranty!
Visit www.vtechphones.com.
Registration
Register your product online for
enhanced warranty support.
Product news
Learn about the latest VTech
products.
Connect the baby unit
NOTES
Use only the power adapter supplied with this
product.
Make sure the electrical outlet is not controlled by
wall switch.
The power adapter is intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place if
they are plugged into a ceiling, under-the-table or
cabinet outlet.
Make sure the baby unit and the power adapter
cord are out of reach of children.
•
•
•
•
a
b
c
g
h
i
j
k
d
e
l
m
f
a
b
c
g
h
i
j
k
d
e
l
m
f
a
b
c
g
h
i
j
k
d
e
l
m
f
1
Light sensor
2
Infrared LEDs
3
Camera
4
Microphone
5
-/VOL/+
Press to adjust the listening volume.•
6
Speaker
7
ON/OFF LED light
On when the baby unit is turned on and
is paired to the parent unit.
Flashes when the baby unit is pairing to
the parent unit.
•
•
8
ON/OFF switch
Slide to turn on or off the baby unit.•
9
Antenna
10
Temperature sensor
11
Power jack
12 Threaded socket
For wall mount installation use.•
13
PAIR
Press and hold to pair to the parent unit
when a desired baby unit slot is chosen
at the parent unit.
•
Before use
Pair extra new baby unit
Each newly purchased baby unit (VM314) must
be paired to your video and audio monitor
system (VM344).
NOTES
You can pair a maximum of four baby units to your
parent unit. Each new baby unit must be paired to
the parent unit before use.
Make sure you power on the parent unit before
pairing.
To pair a baby unit:
Press MENU when the parent unit is not in
use.
Press or to choose Pair/Unpair CAM,
then press SELECT to select.
Press or to choose Pair CAM, then
press SELECT to select.
Press or to choose an empty baby unit
slot, then press SELECT. The parent unit
screen displays Press and hold the pair
button at the CAM for 5 seconds until the
power indicator flashes..
Immediately press and hold PAIR on the
bottom of the baby unit. The LED light
flashes quickly.
When pairing is successful, the screen displays
the view of newly paired baby unit in
SINGLE-CAM mode. The LED light on the new
baby unit remains on.
NOTES
If pairing fails, the screen displays Pairing failed.
Try the pairing process again.
Only one baby unit can be paired at a time.
•
•
1.
2.
3.
4.
5.
•
•
To unpair a baby unit:
NOTE
Make sure you power on the baby unit and the parent
unit before unpairing the baby unit.
On the idle parent unit, press MENU.
Press or to choose Pair/Unpair CAM,
then press SELECT to select.
Press or to choose Unpair CAM, then
press SELECT to select.
Press or to choose a desired baby unit,
then press SELECT.
Press on the parent unit when the screen
displays To unpair CAM X, press the
[ZOOM] key at the Parent Unit..
Press SELECT when the screen displays
Then, press the [MENU/SELECT] key to
confirm..
When unpairing is successful, the screen
displays CAM X is unpaired and returns to
previous menu. If there is no paired baby
unit, the screen displays No CAM is paired..
The LED light on the selected baby unit
flashes slowly.
Positioning the baby monitor
NOTE
This baby monitor is intended as an aid. It is not a
substitute for proper adult supervision, and should not
be used as such.
CAUTION
Keep the baby unit out of the reach of the baby. Never
place or mount the baby unit inside the baby’s crib or
playpen.
Place the baby unit at least 1 meter / 3 feet
away from your baby.
At least 1 meter
(3 feet)
Place parent unit at least 1 meter / 3 feet
away from the baby unit.
At least 1 meter
(3 feet)
1.
2.
3.
4.
5.
6.
7.
1.
2.
NOTE
If you experience audio feedback on either the parent
unit or baby unit, move the parent unit further away
until there is no more audio feedback; or press -/VOL
on the parent unit to lower the audio feedback sound.
TIP
For desktop usage and/or wall mounting the baby
unit, you can refer to Quick Start Guide.
Operating range
The operating range of the baby monitor is up to
300 meters (1,000 feet) outdoors or 50 meters
(160 feet) indoors. The actual operating range
may vary depending on the environmental
conditions and other interferences such as
walls, doors and other obstructions.
General product care
To keep this product working well and looking good,
follow these guidelines:
Avoid putting it near heating appliances and devices
that generate electrical noise (for example, motors
or fluorescent lamps).
DO NOT expose it to direct sunlight or moisture.
Avoid dropping the product or treating it roughly.
Clean with a soft cloth.
DO NOT immerse the baby unit in water and do not
clean them under the tap.
DO NOT use cleaning spray or liquid cleaners.
Make sure the baby unit is dry before you connect
them to the mains again.
Important safety instructions
When using your equipment, basic safety precautions
should always be followed to reduce the risk of fire,
electric shock and injury, including the following:
Follow all warnings and instructions marked on
the product.
Adult setup is required.
This product is intended as an aid. It is not
a substitute for responsible and proper adult
supervision and should not be used as such.
This product is not intended for use as a medical
monitor.
Do not use this product near water. For example,
do not use it next to a bath tub, wash bowl,
kitchen sink, laundry tub or swimming pool, or in a
wet basement or shower.
•
•
•
•
•
•
•
1.
2.
3.
4.
5.
Use only the adapters included with this product.
Incorrect adapter polarity or voltage can seriously
damage the product.
Baby unit power adapter: Input 100-240V AC
300mA 50/60 Hz; output: 5V DC 1000mA
The power adapters are intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
For pluggable equipment, the socket-outlet shall
be installed near the equipment and shall be
easily accessible.
Unplug this product from the wall outlet before
cleaning. Do not use liquid or aerosol cleaners.
Use a damp cloth for cleaning.
Do not cut off the power adapters to replace them with
other plugs, as this causes a hazardous situation.
Do not allow anything to rest on the power cords.
Do not install this product where the cords may be
walked on or crimped.
This product should be operated only from the
type of power source indicated on the marking
label. If you are not sure of the type of power
supply in your home, consult your dealer or local
power company.
Do not overload wall outlets or use an extension
cord.
Do not place this product on an unstable table,
shelf, stand or other unstable surfaces.
This product should not be placed in any area
where proper ventilation is not provided. Slots and
openings in the back or bottom of this product
are provided for ventilation. To protect them from
overheating, these openings must not be blocked
by placing the product on a soft surface such as
a bed, sofa or rug. This product should never be
placed near or over a radiator or heat register.
Never push objects of any kind into this product
through the slots because they may touch
dangerous voltage points or create a short circuit.
Never spill liquid of any kind on the product.
To reduce the risk of electric shock, do not
disassemble this product, but take it to an
authorized service facility. Opening or removing
parts of the product other than specified access
doors may expose you to dangerous voltages or
other risks. Incorrect reassembling can cause electric
shock when the product is subsequently used.
You should test the sound reception every
time you turn on the units or move one of the
components.
Periodically examine all components for damage.
Be aware of possible loss of privacy while using
public airwaves. Conversations may be picked
up by other nursery monitors, cordless phones,
scanners, etc.
Children should be supervised to ensure that they
do not play with the product.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
The product is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
SAVE THESE INSTRUCTIONS
Cautions
Use and store the product at a temperature
between 32
o
F and 104
o
F.
Do not expose the product to extreme cold,
heat or direct sunlight. Do not put the product
close to a heating source.
Make sure the baby unit(s) and the adapter
cord(s) are always out of reach of the baby,
at least 3 feet away from the baby or crib, to
avoid a possible strangulation hazard.
Never place the baby unit(s) inside the baby’s
crib or playpen. Never cover the baby unit(s)
with anything such as a towel or a blanket.
Other electronic products may cause
interference with your baby monitor. Try
installing your baby monitor as far away from
these electronic devices as possible: wireless
routers, radios, cellular telephones, intercoms,
room monitors, televisions, personal
computers, kitchen appliances and cordless
telephones.
Precautions for users of implanted cardiac
pacemakers
Cardiac pacemakers (applies only to digital cordless
devices):
Wireless Technology Research, LLC (WTR), an
independent research entity, led a multidisciplinary
evaluation of the interference between portable
wireless devices and implanted cardiac pacemakers.
Supported by the U.S. Food and Drug Administration,
WTR recommends to physicians that:
Pacemaker patients
Should keep wireless devices at least six inches
from the pacemaker.
Should NOT place wireless devices directly over
the pacemaker, such as in a breast pocket, when it
is turned ON.
WTR’s evaluation did not identify any risk to
bystanders with pacemakers from other persons
using wireless devices.
Electromagnetic fields (EMF)
This VTech product complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this
user’s manual, the product is safe to be used based
on scientific evidence available today.
22.
1.
2.
3.
4.
5.
•
•
What’s in the box Overview
BC