Wireless presenter User Manual Be sure to carefully read this user manual first for the proper use of the Integrative Presenter and keep it for future reference.
Instruction It is a great tool for PowerPoint presentations! With it, you don't need to stand beside your computer or have an additional person click the slide for you! It contains two parts: transmitter and USB receiver. Mini receiver can be put into transmitter. Features: 1. Easy carry The transmitter and receiver are integrated into one unit for easy carry! 2.
2. If battery is low, the control distance will be shorter, please replace battery in time. 3. The presenter will enter into sleep mode if there is no operation about 10 minutes. It will wake up if laser key is pressed. III.
Page Up The point (A position) is remote center. Slide from right of the point to left of the point. Page Down Slide from left of the point to right of the point. Play/Esc Play PowerPoint: Slide from upper of the point to lower of the point, Esc: Repeat above operation (For PowerPoint only) Blank screen Slide from lower of the point to upper of the point (For Laser Press the upper part of presenter to emit laser beam Laser hole Emit laser beam PowerPoint play only) IV.
V. Technical parameters Transmitter RF Frequency RF Output power Sensitivity Control distance Laser wavelength Laser distance Max output Battery 2.437GHz 0dBm -90dBm Up to 10 meters 650nm >200m <1mW or <5mW 1 x AAA Working voltage 1.2~1.5V <100uA Sleep current Dimension 124*35*24mm Receiver Operation system Windows 2000 and above, Windows XP, Vista, Interface Win 7,Win8 USB1.1 , Compatible with USB2.0 Working voltage USB electricity supply (4.5~5.5V) Dimension 36.5*14.6*7mm VI.
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE The product adopts advance RF technology, the USB receiver will identify the first transmitter which is used. If you want to use different transmitters with the same receiver, please pull off the receiver and plug it again, after 6 seconds, press any key of the transmitter you want to use. Then it can work successfully.