User's Manual

INSTRUCTION
It is a wireless presenter as a remote control, a laser pointer and portable storage device. It is tailored as a
convenient handy-tool for presentations, teaching, meetings, speeches, trainings.
It consists of two parts: transmitter and USB receiver.
Ⅰ. Setup:
Plug the receiver into the USB port on your PC. The system will automatically search for the new
hardware and complete the setup.
( Attention : you may need Win98 disk if your computer runs under Win98/SE operating system.. )
Ⅱ. Function:
Laser pointer
Page/scroll up function.
Page/scroll down function.
Built-in flash memory is available (64/128/256/512/1024MB).
Ⅲ. Technical parameters:
Transmitter
Class ClassⅡ Class Ⅲ
Control
distance
> 25m > 25m
Battery AAA x 2 AAA x 2
Working
Voltage
2.4-3.5v 2.4-3.5v
Wireless
method
RF RF
Frequency 433.92MHz 433.92
Modulation OOK OOK
Output 0dbm 0dbm
Laser Power < 1mW/5mW < 1mW/5mW
Wave length 650nm 650nm
Dimension
L=11.9cm
W=3.1cm T=1.7
cm
L=11.9cm
W=3.1cm T=1.7
cm
Weight 44g 44g
Ⅳ. Warning: To avoid the laser radiation to direct eyes !
CAUTIONS: Please note that laser radiation is harmful to the eye. Do not look directly into the aperture
while the laser is operation!
Laser pointer can be harmful if used improperly. Please keep out of reach of children!
Caution:
Changes or modifications to this unit not expressly approved by the party responsible for compliance will
void the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Modifications not authorized by the manufacturer may void users authority to operate this device.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.