WVRX2AP DIGITAL WIRELESS RECEIVER USER MANUAL Patent # US 9,054,743 Patent # CA 2,834,873
INSTALLATION 1. Mount the receiver using 4 screws or the Hook & Hook Velcro.Receiver can be mounted to the rear of a Voyager monitor. 2. Connect the receiver to the monitor as shown in the figure below. 3. Apply power to the monitor & receiver and select the correct video input on the monitor. "Press & Hold the Pairing Button" will be displayed. 4. Press the Pair Button on the receiver for 5 seconds and you should see "Pairing" and then apply power to the WVTX2AP.
CONTROLS AND OPERATION 1. PAIR Button Press and hold pair button for 5 seconds on receiver module to activate pairing process, The monitor screen will display pairing count screen with blinking status LED. 4 3 1 2 49 Make sure transmitter module is unpowered at first.
FCC NOTES IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted.