INSTALLATION INSTRUCTIONS VOLT® Low Voltage Landscape Lighting VOLT® Path & Area Light Stem VSM-2407 & VSM-1203 Help Hotline: 1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST) Specifications and product details subject to change without notice. © Copyright 2019, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved. customersupport@voltlighting.com • 813.978.
INSTALLATION INSTRUCTIONS VOLT® Path & Area Light Stem VSM-2407 & VSM-1203 ! Important: Please Read Before Installation This fixture is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty. These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations. 1.
Package Contents A. (1) Stem Parts Required (sold separately) A. (1) Hat B. (1) Bulb C. Stake Product Dimensions Max Spread Hat Pictured Here on Standard stem Max Spread Hat Pictured Here on Mini stem 9” 2.5” 22.5” customersupport@voltlighting.com • 813.978.
INSTALLATION INSTRUCTIONS VOLT® Path & Area Light Stem VSM-2407 & VSM-1203 1 Remove Stem Top Loosen the stem top and remove it from the stem. Stem Top Stem 2 Install Bulb Bulb Socket 3 Insert the bulb with correct wattage and type marked on the fixture label and push firmly into place. CAUTION: Do not exceed maximum wattage marked on luminaire label. Install Stem Top Place the stem top over the bulb and thread the stem top onto the stem. Hand tighten until snug. Stem Top Stem w w w.
4 Install Stake Board Stake Ground Soil 5 Determine the desired location for mounting the fixture. Hammer the stake into the ground until the flange of the stake is flush to grade. To avoid damage to the stake, place a board on top of the stake while hammering. NOTE: If the ground is hard and the stake is difficult to install, make a crosscut in the ground using a flat shovel. Install Stem to Stake Clear away an area in the ground at the wireway slot on the top of the stake.
INSTALLATION INSTRUCTIONS VOLT® Path & Area Light Stem VSM-2407 & VSM-1203 6 Wire Connection Pigtail Wire Connectors Main Supply Cable Strip both leads from the luminaire pigtail. Using two wire connectors (sold separately), connect the leads from the luminaire to the main supply cable leads. 7 Install Hat Place the hat of your choice onto the stem top and secure it with the finial. Hand tighten until snug. Finial Hat of your choice Shield w w w. v o l t l i g h t i n g .
Install/Replace Bulb Remove the finial, hat and stem top to expose the bulb. Replace it with the correct wattage and type marked on the fixture label. Then, reinstall the stem top and hat. IMPORTANT: Bulbs must be protected from moisture and dust at all times. Always reinstall the stem top and hat when removed. customersupport@voltlighting.com • 813.978.
Help Hotline: 1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST) w w w. v o l t l i g h t i n g . c o m Specifications and product details subject to change without notice. © Copyright 2019, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved. customersupport@voltlighting.com • 813.978.3700 IS-VSM-2407/1203-ver4.