VOKKERO GUARDIAN US GUARDIAN Plus and GUARDIAN O2O User Guide Version 1.0.0 211292A VOKKERO VOKKERO Adeunis NA 25 Main Street, 3rd Floor Tuckahoe, NY 10707 www.vokkerousa.com Adeunis group 283 rue Louis Néel - Parc Technologique Pré Roux 38920 CROLLES - France www.vokkero.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 PRÉAMBULE / PREAMBLE • Ce guide décrit les fonctionnalités du produit Vokkero® Guardian WI, ses options et ses accessoires. Il explique comment le configurer pour permettre une extension du système de conférence vers un réseau filaire. • This guide describes the functionality of the Vokkero® Guardian WI product, options and accessories. It explains how to configure it to allow an extension of the conference system to a wired network.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 Table des matières PRÉAMBULE / PREAMBLE INFORMATIONS DISCLAIMER TECHNICAL SUPPORT COMPLIANCE TO FCC US/CAN ENVIRONMENTAL RECOMMENDATIONS WARNINGS RECOMMANDATIONS REGARDING USE DISPOSAL OF WASTE BY USERS IN PRIVATE HOUSEHOLDS WITHIN THE USAN UNION INTRODUCTION 1. SYSTEM INSTALLATION PROCEDURE 2. STARTING UP THE TERMINAL 2.1. Screen Icons (by Default) 2.2. Setting up Audio Conference 2.3. Connecting a headset 2.3.1. Plugging in a headset 2.3.2.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 INFORMATIONS Document Information Title VOKKERO GUARDIAN US Subtitle US Document type User Guide Version Version 1.0.0 This document applies to the following products: Nom Référence VOKKERO GUARDIAN US Up to : ARF8320 DISCLAIMER This document and the use of any information contained therein, is subject to the acceptance of the VOKKERO terms and conditions. They can be downloaded from www.vokkerousa.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 COMPLIANCE TO FCC US/CAN • This device complies with part 15 of the FCC rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1). this device may not cause Harmful interference, and (2). this device must accept any interference received, including interference that may cause undesired operation of the device.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante. FOR PORTABLE DEVICE USAGE (<20cm from body/SAR needed) Radiation Exposure Statement: The product comply with the FCC and ISED portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 USAGE RESTRICTIONS : THE USE OF VOKKERO GUARDIAN IN US/CAN IMPORTANT: Before using the device, please observe the legal provisions in force in your country. Table ID Frequencies for VOKKER-GUARD-NA001-PL US 1 26 channels within the 902.187MHz to 927.312MHz band US 2 28 channels within the 903.125MHz to 927.500MHz band US 3 25 channels within the 916.698MHz to 927.573MHz band US 4 27 channels within the 902.188MHz to 916.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 ENVIRONMENTAL RECOMMENDATIONS All superfluous packaging materials have been eliminated. We have done everything possible to make it easy to separate the packaging into three types of materials: cardboard (box), expanded polystyrene (filler material) and polyethylene (packets, foam protective sheets). Your device is composed of materials that can be recycled and reused if it is dismantled by a specialist company.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 RECOMMANDATIONS REGARDING USE • • • • • • • Before using the system, check that the power supply voltage shown in the user manual corresponds to your supply. If it doesn’t, please consult your supplier. Place the device against a flat, firm and stable surface.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 INTRODUCTION The operations described below allow you to rapidly and easily implement your VOKKERO Guardian communication sys-tem. All the operations described are valid for all the VOKKERO® Guardian terminals listed below: ARF8320 Note: Your product reference is given on the label on the back of the terminal housing.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 The operations described below allow you to rapidly and easily implement your VOKKERO Guardian communication sys-tem. All the operations described are valid for all the VOKKERO® Guardian terminals listed below: Antenna Headset connector Flexible radio antenna. Connect to a headset (must be compatible with the terminal). LED Device on and Network connection. «Volume» selector Trigger Button to adjust the volume of the headset loudspeaker.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 1.1. General Technical Specifications Battery Charging without the terminal Screen Configurator display screen. LED Terminal charge Red : no terminal or defective terminal Orange : terminal charging Vert : terminal charged Extension connection Up to 4 extensions can be connected Power supply connector Power jack USB connection For product updates or Guardian WI Connection (Optional). General Specifications Value Supply voltage 3.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 Specifications Value AC/DC Power Converter (standard) 100 to 240V 12VDC/5A - 50/60Hz (maximum of 10 terminals charging) AC/DC power converter (extended system) 100 to 240V, 12 VDC/6.67A - 50/60Hz (more than 10 terminals charging) Operating temperature -5°C / +40°C Dimensions Configurator/Charger 337 x 95 x 58mm Dimension extension 216 x 95 58mm Weight configurator/charger 470g Weight extension 310g 2.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2.1. Screen Icons (by Default) Role Indicates the role of the terminal M1: Master role 2 to 16: Other roles Network status Shows that the terminal is connected to a network. Battery level US2 Channel Number of the communications channel. Microphone status Either no microphone connected, or microphone Off. 2.2. Setting up Audio Conference You can set up a VOKKERO audio conference.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2.3. Connecting a headset Several types of headsets from the VOKKERO range can be connected to VOKKERO Guardian. The headset is automati-cally detected by the terminal when the headset is plugged in. 2.3.1. Plugging in a headset Plug the headset into the slot at the top of the product, beside the LCD.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2.4. Terminal operation 2.4.1. Volume Adjust the terminal volume with the Volume trigger button. • Push the trigger upwards to increase the volume • Push the trigger downwards to decrease the volume When you increase or decrease the volume, you will hear a beep. When you reach the maximum or minimum volume setting, you will hear 2 consecutive beeps. The volume setting is also indicated on the terminal LCD.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2.4.4. “Micro” button (Latch mode by default) Adjust the Microphone setting using the Micro button. The microphone can be configured in various modes using the configurator; for full information on available modes, refer to §4.3.1. Check the microphone status on the terminal LCD: • • if there is a Struck-through micro icon, then the microphone is Off and you can be heard on the network.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2.4.7. Side Tone By default, the side tone is disabled. To activate the side tone, press and hold the centre of the volume knob. The product then displays the side tone menu. To choose among the following options toggle the trigger: • Side tone disabled (OFF) • Side tone volume 1, 2 or 3 The system automatically exits the menu after a few seconds.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 3. DESCRIPTION OF THE CONFIGURATOR The configurator does not have an On-Off switch. To turn it on, the configurator must be connected to the power unit provided with the VOKKERO Guardian. The configurator has a USB port for updates. The configurator screen is a high-resistance touchscreen. The configurator can also be used to download products.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 Start the configuration by selecting “GO” on the screen, and then validating the confirmation screen; the configuration starts. If the configuration completes successfully, the indication “DONE” displays. Alternatively, the indication “ERROR” displays if a problem is encountered. To return to the Home Screen, use the left arrow. 3.3.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 3.3.1. Configuring the terminal This screen indicates the terminals present on the configurator. The charge status as well as the name of each terminal displays. The terminals display in their order of presence on the configurator, going from the closest (position 1) to the furthest away. To modify a product, select the product row; this displays all the settings available for the selected product.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2 - Microphone action The central button can have a number of operating modes: - Latch: press to switch the microphone from Microphone On to Microphone Off; the microphone status displays on the terminal LCD - Push to talk: the microphone is On for as long as the button is pushed and held. To note: it is implemented a latency of a second at the closing of the microphone after release of the button.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 5- Advanced settings Provides access to the following options: - Assign buttons: to change the functions of the buttons on the terminal - Alarm button: to change the press mode of the alarm button - Expert mode: Users cannot access this mode as it has settings that can disrupt the smooth-running of your VOKKERO® Guardian system. 5.1 Assignment buttons Reset the functions of the terminal buttons or disable certain functions.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 6 - Version Shows you the factory version of the terminal used. 7 - Factory settings This menu returns, to the factory setting, a product or all products connected to the configurator. After selecting and validating your choice, the configurator lets you know if the return to factory settings completed successfully. To finalize the operation, select the arrow on the bottom left-hand side to return to the configuration screen of the terminals.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 3.3.2. System configuration In this screen you can see all the settings related to the system configuration. The settings in this menu apply to all the terminals present on the configurator.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 2 - Encryption The encryption key is used to make communications within a given system secure. Only the devices using the same encryption key are authorized to communicate on the network. Several options are available: • • • No encryption: the communications are not secure; all the Guardian devices can join the network, even if they have no encryption key.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 4.1 - Updating terminals To update terminals you have to use a USB key. Contact your vendor to obtain the most recent software version. The USB key used must be < or = 4Go.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 4.2 - Updating the configurator To update the configurator you have to use a USB key. Contact your vendor to obtain the most recent software version. The USB key used must be < or = 4Go.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 3.3.3. Configuring the configurator Use this setting to adjust the screen. In this area, you can adjust the screen lighting, calibrate the touchscreen, and lock the configurator. 1 - Adjusting the screen lighting Slide the cursor from left and right to decrease and increase, respectively, screen lighting.
VOKKERO GUARDIAN US - Plus and O2O - User Guide V1.0.0 3 - Locking Allows you to block access to the configurator using a PIN code. In Lock mode, only the «Quick Config” option is available. You can only access the other settings after validating the PIN code. Note: The PIN code consists of 1 to 6 digits Once the lock has been activated, the PIN code can be modified or deactivated (see screen below showing the options available in the «Lock» menu, once the lock has been activated). 3.3.4.