VOKKERO GUARDIAN US GUARDIAN PLUS / GUARDIAN O2O / GUARDIAN REF User Guide Version 3.0 211292A VOKKERO VOKKERO VOGO NA (North America) 25 Main Street, 3rd Floor Tuckahoe, NY 10707 www.vokkerousa.com VOGO 101, place Pierre Duhem, Immeuble Les Centuries II, 34000 Montpellier, France www.vokkero.
VOKKERO GUARDIAN US - User Guide V3.0 PRÉAMBULE / PREAMBLE • Ce guide décrit les fonctionnalités des produits VOKKERO GUARDIAN US (GUARDIAN PLUS / GUARDIAN O2O / GUARDIAN REF), ses options et ses accessoires. • This guide describes the functionality of the VOKKERO GUARDIAN US (GUARDIAN PLUS / GUARDIAN O2O / GUARDIAN REF) products, options and accessories. • Aucun extrait de ce document ne pourra être reproduit ou transmis (sous format électronique ou papier, ou par photocopie) sans l’accord de VOGO.
VOKKERO GUARDIAN US - User Guide V3.0 PRÉAMBULE / PREAMBLE 2 INFORMATIONS 4 DISCLAIMER 4 TECHNICAL SUPPORT 4 COMPLIANCE TO FCC US/CAN 5 ENVIRONMENTAL RECOMMENDATIONS 8 WARNINGS 8 RECOMMANDATIONS REGARDING USE 9 DISPOSAL OF WASTE BY USERS IN PRIVATE HOUSEHOLDS WITHIN THE USAN UNION 9 INTRODUCTION 10 1. SYSTEM INSTALLATION PROCEDURE 10 2. STARTING UP THE TERMINAL 13 2.1. Screen Icons (by Default) 14 2.2. Setting up Audio Conference 14 2.3. Connecting a headset 15 2.3.1.
VOKKERO GUARDIAN US - User Guide V3.0 INFORMATIONS Document Information Title VOKKERO GUARDIAN US Subtitle GUARDIAN PLUS / GUARDIAN O2O / GUARDIAN REF Document type User Guide Version Version 3.
VOKKERO GUARDIAN US - User Guide V3.0 COMPLIANCE TO FCC US/CAN • This device complies with part 15 of the FCC rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1). this device may not cause Harmful interference, and (2). this device must accept any interference received, including interference that may cause undesired operation of the device.
VOKKERO GUARDIAN US - User Guide V3.0 FOR PORTABLE DEVICE USAGE (<20cm from body/SAR needed) Radiation Exposure Statement: The product comply with the FCC and ISED portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
VOKKERO GUARDIAN US - User Guide V3.0 USAGE RESTRICTIONS : THE USE OF VOKKERO GUARDIAN IN US/CAN IMPORTANT: Before using the device, please observe the legal provisions in force in your country. Table ID Frequencies for GUARDIAN PLUS (VOKKER-GUARD-NA001-PL) US 1 US 2 US 3 US 4 Frequencies for GUARDIAN O2O (VOKKER-GUARD-NA001-O2O) O2O-1 O2O-2 O2O-3 O2O-4 O2O-5 Frequencies for GUARDIAN REF (VOKKER-GUARD-FCC001-REF) US1 US2 US3 US4 US5 US6 All rights to this manual are the exclusive property of VOKKERO.
VOKKERO GUARDIAN US - User Guide V3.0 ENVIRONMENTAL RECOMMENDATIONS All superfluous packaging materials have been eliminated. We have done everything possible to make it easy to separate the packaging into three types of materials: cardboard (box), expanded polystyrene (filler material) and polyethylene (packets, foam protective sheets). Your device is composed of materials that can be recycled and reused if it is dismantled by a specialist company.
VOKKERO GUARDIAN US - User Guide V3.0 RECOMMANDATIONS REGARDING USE • • • • • • • Before using the system, check that the power supply voltage shown in the user manual corresponds to your supply. If it doesn’t, please consult your supplier. Place the device against a flat, firm and stable surface. The device must be installed in a location that is sufficiently ventilated so that there is no risk of internal heating and it must not be covered with objects such as newspapers, cloths, curtains, etc.
VOKKERO GUARDIAN US - User Guide V3.0 INTRODUCTION The operations described below allow you to rapidly and easily implement your VOKKERO Guardian communication sys-tem. All the operations described are valid for all the VOKKERO® Guardian terminals listed below: VO8320A - VO8320B - VO8320C - VO8320D - VO8320E - VO8320F - VO83020G - VO8320H - VO83020I - VO8320J Note: Your product reference is given on the label on the back of the terminal housing.
VOKKERO GUARDIAN US - User Guide V3.0 The operations described below allow you to rapidly and easily implement your VOKKERO Guardian communication system. All the operations described are valid for all the VOKKERO® Guardian terminals listed below: Antenna Headset connector Flexible radio antenna. Connect to a headset (must be compatible with the terminal). LED Device on and Network connection. «Volume» selector Trigger Button to adjust the volume of the headset loudspeaker.
VOKKERO GUARDIAN US - User Guide V3.0 1.1. General Technical Specifications Battery Charging without the terminal Screen Configurator display screen. LED Terminal charge Red : no terminal or defective terminal Orange : terminal charging Vert : terminal charged Extension connection Up to 4 extensions can be connected Power supply connector Power jack USB connection For product updates or Guardian WI Connection (Optional). General Specifications Value Supply voltage 3.
VOKKERO GUARDIAN US - User Guide V3.0 Specifications Value AC/DC Power Converter (standard) 100 to 240V 12VDC/5A - 50/60Hz (maximum of 10 terminals charging) AC/DC power converter (extended system) 100 to 240V, 12 VDC/6.67A - 50/60Hz (more than 10 terminals charging) Operating temperature -5°C / +40°C Dimensions Configurator/Charger 337 x 95 x 58mm Dimension extension 216 x 95 58mm Weight configurator/charger 470g Weight extension 310g 2.
VOKKERO GUARDIAN US - User Guide V3.0 2.1. Screen Icons (by Default) Role Indicates the role of the terminal M1: Master role 2 to 16: Other roles Network status Shows that the terminal is connected to a network. Battery level US2 Channel Number of the communications channel. Microphone status Either no microphone connected, or microphone Off. 2.2. Setting up Audio Conference You can set up a VOKKERO audio conference.
VOKKERO GUARDIAN US - User Guide V3.0 2.3. Connecting a headset Several types of headsets from the VOKKERO range can be connected to VOKKERO Guardian. The headset is automati-cally detected by the terminal when the headset is plugged in. 2.3.1. Plugging in a headset Plug the headset into the slot at the top of the product, beside the LCD.
VOKKERO GUARDIAN US - User Guide V3.0 2.4. Terminal operation 2.4.1. Volume Adjust the terminal volume with the Volume trigger button. • Push the trigger upwards to increase the volume • Push the trigger downwards to decrease the volume When you increase or decrease the volume, you will hear a beep. When you reach the maximum or minimum volume setting, you will hear 2 consecutive beeps. The volume setting is also indicated on the terminal LCD. The sound level can be adjusted between 0 and 10.
VOKKERO GUARDIAN US - User Guide V3.0 2.4.4. “Micro” button (Latch mode by default) Adjust the Microphone setting using the Micro button. The microphone can be configured in various modes using the configurator; for full information on available modes, refer to §4.3.1. Check the microphone status on the terminal LCD: • • if there is a Struck-through micro icon, then the microphone is Off and you can be heard on the network.
VOKKERO GUARDIAN US - User Guide V3.0 2.4.7. Side Tone By default, the side tone is disabled. To activate the side tone, press and hold the centre of the volume knob. The product then displays the side tone menu. To choose among the following options toggle the trigger: • Side tone disabled (OFF) • Side tone volume 1, 2 or 3 The system automatically exits the menu after a few seconds.
VOKKERO GUARDIAN US - User Guide V3.0 3. DESCRIPTION OF THE CONFIGURATOR The configurator does not have an On-Off switch. To turn it on, the configurator must be connected to the power unit provided with the VOKKERO Guardian. The configurator has a USB port for updates. The configurator screen is a high-resistance touchscreen. The configurator can also be used to download products.
VOKKERO GUARDIAN US - User Guide V3.0 Start the configuration by selecting “GO” on the screen, and then validating the confirmation screen; the configuration starts. If the configuration completes successfully, the indication “DONE” displays. Alternatively, the indication “ERROR” displays if a problem is encountered. To return to the Home Screen, use the left arrow. 3.3.
VOKKERO GUARDIAN US - User Guide V3.0 3.3.1. Configuring the terminal This screen indicates the terminals present on the configurator. The charge status as well as the name of each terminal displays. The terminals display in their order of presence on the configurator, going from the closest (position 1) to the furthest away. To modify a product, select the product row; this displays all the settings available for the selected product.
VOKKERO GUARDIAN US - User Guide V3.0 2 - Microphone action The central button can have a number of operating modes: - Latch: press to switch the microphone from Microphone On to Microphone Off; the microphone status displays on the terminal LCD - Push to talk: the microphone is On for as long as the button is pushed and held. To note: it is implemented a latency of a second at the closing of the microphone after release of the button.
VOKKERO GUARDIAN US - User Guide V3.0 5- Advanced settings Provides access to the following options: - Assign buttons: to change the functions of the buttons on the terminal - Alarm button: to change the press mode of the alarm button - Expert mode: Users cannot access this mode as it has settings that can disrupt the smooth-running of your VOKKERO® Guardian system. 5.1 Assignment buttons Reset the functions of the terminal buttons or disable certain functions.
VOKKERO GUARDIAN US - User Guide V3.0 6 - Version Shows you the factory version of the terminal used. 7 - Factory settings This menu returns, to the factory setting, a product or all products connected to the configurator. After selecting and validating your choice, the configurator lets you know if the return to factory settings completed successfully. To finalize the operation, select the arrow on the bottom left-hand side to return to the configuration screen of the terminals.
VOKKERO GUARDIAN US - User Guide V3.0 3.3.2. System configuration In this screen you can see all the settings related to the system configuration. The settings in this menu apply to all the terminals present on the configurator.
VOKKERO GUARDIAN US - User Guide V3.0 2 - Encryption The encryption key is used to make communications within a given system secure. Only the devices using the same encryption key are authorized to communicate on the network. Several options are available: • • • No encryption: the communications are not secure; all the Guardian devices can join the network, even if they have no encryption key.
VOKKERO GUARDIAN US - User Guide V3.0 4.1 - Updating terminals To update terminals you have to use a USB key. Contact your vendor to obtain the most recent software version. The USB key used must be < or = 4Go.
VOKKERO GUARDIAN US - User Guide V3.0 4.2 - Updating the configurator To update the configurator you have to use a USB key. Contact your vendor to obtain the most recent software version. The USB key used must be < or = 4Go.
VOKKERO GUARDIAN US - User Guide V3.0 3.3.3. Configuring the configurator Use this setting to adjust the screen. In this area, you can adjust the screen lighting, calibrate the touchscreen, and lock the configurator. 1 - Adjusting the screen lighting Slide the cursor from left and right to decrease and increase, respectively, screen lighting.
VOKKERO GUARDIAN US - User Guide V3.0 3 - Locking Allows you to block access to the configurator using a PIN code. In Lock mode, only the «Quick Config” option is available. You can only access the other settings after validating the PIN code. Note: The PIN code consists of 1 to 6 digits Once the lock has been activated, the PIN code can be modified or deactivated (see screen below showing the options available in the «Lock» menu, once the lock has been activated). 3.3.4.
QUICK START GUIDE FOR GUARDIAN REF CONFIGURATING THE VOKKERO GUARDIAN REF SYSTEM FOR VAR 1 2 Place at least 4 GUARDIAN REF terminals on the configurator. Be 3 CONNECT WI MAIn to the configurator with sure that all terminals USB cable the charging docks; still and charging led will be orange; GROUP MODE fully charged green; not is activated seated properly will be red.
QUICK START GUIDE FOR GUARDIAN REF 1 GAME TIME USE OF THE VOKKERO GUARDIAN REF SYSTEM THROUGH THE TERMINALS Remove the terminals from the configurator, power your terminal and connect a headset to all To disconnect the headset, grasp the secure connector ring. WARNING, do not turn the connector or pull the cable! 2 Line up the 2 red marks of the product and the connector 3 Adjust the volume by switching the trigger knob up & down.