User's Manual

Controls, Instruments 25
A - Light-emitting diode for alarm system
Alarm System,
Passenger Compartment
Monitoring
This device complies with:
Part 15 of the FCC Rules
RSS-210 of Industry Canada.
Operation is subject to the following two conditi-
ons:
1. This device may not cause harmful interfe-
rence, and
2. this device must accept any interference recei-
ved, including interference that may cause un-
desired operation.
Note
The manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifi-
cations to this equipment.
Such modification could void the user’s authority
to operate the equipment.
The alarm system and passenger compartment
monitoring system are switched on when the
doors are locked with the key or remote control.
f Please observe the chapter “CENTRAL LO-
CKING” on Page 22.
Unlocking the vehicle by using the key in the
door lock and opening the door may activate
the alarm system within 10 seconds.
Function indication
If the alarm system is activated, light-emitting
diode A in the central locking switch flashes.
If, after locking, the light-emitting diode does not
flash or, after ten seconds, it emits double flas-
hes, then not all alarm contacts are closed.
Additionally, a brief horn signal sounds.
When the doors are unlocked, the alarm system
and infrared passenger compartment monitoring
system are switched off and the light-emitting
diode goes off.

Summary of content (2 pages)