Quick Start Guide

BT-1 User’s Guide

BT-1

BLUETOOTH

MUSIC RECEIVER

LINE

OUT

VOL

Getting Connected (For BT-1L only)

Pairing

Installation (For BT-1 only)

1. When powered, the BT-1/L will automatically be discoverable in

pairing mode (indicated by the blinking LED).

2. Go to the Bluetooth settings on your Bluetooth device and pair

the device labeled VOCOPRO. This will cause the LED to remain lit

signaling a successful pairing.

NOTE: If you are prompted for a password, use: 0000.

3. Use the volume knob to adjust volume of bluetooth audio output.

4. Enjoy your music!

1. Connect the power supply to the BT-1L and a power outlet.

2. Using the supplied 1/8” to 1/8” audio cable, connect one end to the audio output on the

BT-1, connect the other end to your powered speaker or audio system.

3. Install the antenna by aligning it to the center of the antenna input and turn clockwise.

1. Remove the expansion port cover plate from your compatible host unit.

2. Find the 6-pin cable and connect its connector to the 6-pin connector on the back of the BT-1.

3. Slide the BT-1 into the port and secure with the screws.

4. Install the antenna by aligning it to the center of the antenna input and turn clockwise.

Antenna

Connector

2 3

Antenna

Connector

NOTE: Do not connect 6-pin

connector and 5V power

adapter simultaneously.

PAGE 1
BT-1 User’s Guide Getting Connected (For BT-1L only) 1 2 3 Connector Antenna 1. Connect the power supply to the BT-1L and a power outlet. 2. Using the supplied 1/8” to 1/8” audio cable, connect one end to the audio output on the BT-1, connect the other end to your powered speaker or audio system. 3. Install the antenna by aligning it to the center of the antenna input and turn clockwise. Installation (For BT-1 only) NOTE: Do not connect 6-pin connector and 5V power adapter simultaneously. 1.
PAGE 2
Specifications Troubleshooting • Bluetooth: Version 3 • Frequency Band 2.402GHz~2.480GHz ISM Band If you experience performance issues with the BT-1/L, perform the following: • Audio input: Bluetooth 1. Make sure the BT-1/L is still paired. • Audio output: 1/8” mini-jack This can be verified by checking the LED. • Power - 5VDC 200 mA • Solid LED: Paired 6-Pin Connector • Blinking LED: Not paired If need be, repeat the process to pair your Bluetooth device. 2.