User's Manual Part 6

ManualsBrandsVocollect ManualsElectronicsTalkman-OPEN (Apollo) terminal

';f;:i}ri~~~~%j,;;~~!"';~"j:.;;:

Talkman@ Open Operator's Guide

,f~

0.:.

,,; ,

..'

'...L'

,,"':-.

0:.."

The T aikman terminal needs a ch,arged

battery to operate. The battery is placed

into a battery housing assembly I<jit. This

section shows you how to place ttle battery

into the housing assembly and how to

maintain the battery.

.-:

..~

...'.,

I."'.

..."

1i;jf

..."

,~}~

'\.,j'

;'..

~.;.

~,~

T he battery is the primary power source for the T alkman

terminal. It is charged by the battery charger, then is

connected to the Talkman tenninal. If you find that the

Talkman terminal can no longer run as long as it used to with

a fully charged battery , the battery may need to be replaced.

..if

.I'

}

;

""'

Along with your Talkman terminal, you received a battery housing

assembly kit. Please refer to Appendix B: Battery Housing Assembly

Kit guide for directions on how to house your battery.

.c" , ..

~~'j

Summary of content (6 pages)

PAGE 1
';f;:i}ri~~~~%j,;;~~!"';~"j:.;;: Talkman@ Open Operator's Guide ,f~ 0.:. ,,; , ..' ~' '. '...L' ,,"':-. 0:.." -' .-: ..~ ~j O' ...'., I."'. ..." A 1i;jf ..." , The Taikman terminal needs a ch,arged battery to operate. The battery is placed into a battery housing assembly I
PAGE 2
Talkman@ Open Operator's Guide The battery is chargedby connecting it to the battery charger. Do the following to chargethe battery: Figure 5-1, Charging the Battery ;BATTERY J! PACK ~ ~ 1. Plug the battery charger into the power supply and the power supply into a known good electrical outlet. The power light on the battery charger will go on. 2. Place the battery into an unused receptacle on the battery charger (seeFIg. 5-1).
PAGE 3
~:i"";~~i;\:~.~:~;ji;;1 Talkman@ ~, ;f:~i1~~;};; i~;:ir;{'~i;!'c:Ji:::~:~; Open Operator's ;;:;~Jrl~~~,~~; .c. ~ Guide 3. The battery is charged and ready for use when the indicator light on the battery charger turns green. If the red battery light is on and solid, it is being charged, but is not yet fully charged.
PAGE 4
\~::f~;:~:Ji.ij;\['~;!.'.: ,;ri;.~,[~ f Talkman@ Open Operator's Guide 1. Slide the battery into T alkman as shown in Fig. 6-2. Figure 5-2 Installing Battery in the T alkman 0 BATTERY PACK )~3 0 NOTCH t ~ 0 !A ~ BATTERY PACK' RELEASE BUTTON i---r ~~ ~\ \\ \ ,-,~!:-.:;.\i' ;h~):~;;~; Battery compartment in Talkman 39 I;~ R~i~ii;
PAGE 5
:1!:. .~;~1:;i~i.;i. Talkman@ Open Removing Operator's Battery ~;~~,;~:~- Guide from Talkman To remove the battery from Talkman: ,0;' - 1. Turn offTalkman by pressing and holding d1eyellow play / pause button until d1eT a1kmantetminalIED goes from solid red to off. w ARNIN G: Do not remove battery when the Ta1kman tenninal is only paused (blinking green LED). All data gathered will be lost! 2. Hold Talkman in one hand with the buttons facing up.
PAGE 6
J i1i;~I::~;~: ~;,:;[~: Talkman@ !~i~ Open Operator's Guide Figure 5-3} PlacingTalkman in the Talkman Cradle I/Ti ,JrJ I C~ PDV£R --L - Lu;II~.:::JIJ, '"-'" CRAnL[ .. 41 "..,.