Instruction Manual

ManualsBrandsVMP ManualsAccessories20" 5U Vertical Equipment Wall Cabinet

ERVWC-5U20 / ERVWC-5U36

Instruction Sheet For:

For more information, please contact us at:

345 Log Canoe Circle, Stevensville, Maryland 21666

Toll Free: 877.281.2169 Phone: 410.643.6390 Fax: 410.643.6615

www.videomount.com

tech@videomount.com

5U Vertical Wall Mount Rack Instruction Manual

Summary of content (5 pages)

PAGE 1
Instruction Sheet For: ERVWC-5U20 / ERVWC-5U36 5U Vertical Wall Mount Rack Instruction Manual For more information, please contact us at: 345 Log Canoe Circle, Stevensville, Maryland 21666 Toll Free: 877.281.2169 Phone: 410.643.6390 Fax: 410.643.6615 www.videomount.com tech@videomount.
PAGE 2
Rear Cabinet Panel Vertical Mounting Bracket Vertical Mounting Rails Patch Panel Mounting Bracket Lag Screw - 6M x L70mm Wall Anchor M6 * 1/2” Screw 12-24 * 5/8” Rack Screw Cabinet Keys 3 4 5 6 7 8 9 10 11 Dimensions (HxWxD) 28.8” x 25.6” x 9.75” 42.75” x 25.6” x 9.75” Model No. ERVWC-5U20 ERVWC-5U36 SPECIFICATIONS 8 Top Panel Door 2 7 Front Door 1 9 Part Name Part No.
PAGE 3
Safety First - These enclosures are heavy and you should always have at least 2 people involved with moving, unpacking and mounting them. - Please verify that your mounting surface will safely support the combined weight of the enclosure, mounting hardware and equipment installed in the cabinet. Confirm that the mounting surface is safe to drill through. Please note that only mounting hardware for mounting to wooden studs is provided with the unit.
PAGE 4
Section 2 - Vertical Mounting Rails Your enclosure provides 2 threading options based upon your preference and the equipment you are using. One side of the rail is threaded for M6 hardware and the other side is threaded for 1224. The rails are visibly labeled with both options. Position the rails with the desired thread pattern on top. To install your equipment, use the included M6 or 12-24 hardware, or the hardware provided with your equipment to secure equipment to the rails.
PAGE 5
Section 5 - Installing your Equipment NOTE: The enclosure must be mounted and stabilized prior to installing your equipment. If you are using sliding equipment rails, be careful when extending the rails. Do not extend more than one set of sliding equipment rails at one time. Avoid extending sliding equipment rails near the top of the enclosure. Each rack unit is marked on the rail for your convenience. To install your equipment, lower it into the enclosure and set it on the mounting rails.