Outdoor Day/Night Weather-proof Quick Installation Guide English Français Español Deutsch Português Italiano Türkçe Polski Русский Česky Svenska IP7330 This guide describes the basic functions of IP7330. All detailed d t il d information i f ti is i described d ib d in i the th user's ' manual.
English Warning Before Install Power off the Network Camera as soon as it is found smoking or smelt unusual. Refer to your user’s manual for the operating temperature. Contact your distributor when such cases happen. Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera when it’s lightening. Do not insert any object into the Network Camera, such as needles. Do not drop the Network Camera.
1 Package Contents IP7330 Liquid tight connectors (3 holes, for backup use) Silica gel Camera stand Silica gel Power adapter RJ45 female/female coupler Quick installation guide / Warranty card Software CD ST7501 Central Management Software EN-2
English 2 Physical Description Front panel IR LED Lens Light sensor Back panel Status LED Reset button Connectors General I/O terminal block Ethernet 10/100 RJ45 plug Power cord socket (black) EN-3
3 Hardware Installation 1. Loose the liquid tight connectors, and then remove the rubber. 2. Loose the back cover. 3. Tear down the aluminum foil vacuum bag and take out the silica gel. Attach the supplied silica gel to the inner side of the Network Camera. (Please replace the silica gel with a new one if you open the back cover after installation.) 4. Make sure all cable lines are securely connected. 5. Tighten the back cover, rubber and liquid tight connectors. 6.
English 4 Network Deployment General Connection (without PoE) 1. If you have external devices such as sensors and alarms, make connections from general I/O terminal block. AV24V AC24V DI GND AV24V: 24V+ AC24V: 24VDI : Digital Input GND : Ground 2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch. Use Category 5 Cross Cable when Network Camera is directly connected to PC. POWER LINK COLLISION 1 2 3 4 5 RECEIVE PARTITION 3.
Power over Ethernet (PoE) When using a PoE-enabled switch The Network Camera is PoE-compliant, allowing transmission of power and data via single Ethernet cable. See the following illustration to connect the Network Camera to a PoE-enabled switch via Ethernet cable. POWER COLLISION 1 2 3 4 5 LINK RECEIVE PARTITION PoE switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.
English 5 Assigning IP Address 1. Install the "Installation Wizard 2" under the Software Utility directory from software CD. 2. The program will conduct analyses on your network environment. After your network is analyzed, please click on the "Next" button to continue the program. IW2 Installation Wizard 2 3. The program will search the VIVOTEK Video Receivers, Video Servers or Network Cameras on the same LAN. 4. After searching, the main installer window will pop up.
6 Ready to Use 1. Access to the Network Camera from the Internet. 2. Retrieve live video through web browsers or recording software. For further setup, please refer to user’s manual on the software CD.
Outdoor Day/Night Weather-proof Quick Installation Guide English ᖅϛ ᙏϛ Рҏᇭ Français Español Deutsch Português Italiano Türkçe Polski Русский Česky Svenska IP7330 This guide describes the basic functions of IP7330. All d detailed t il d iinformation f ti iis d described ib d iin th the user's ' manual.
