FT9361-R Installation Guide -Access control Reader- 3 4 1 4 2 Physical Description No. Description No.
. Installation 2.1 Bracket Moumnt * Themountbracketwillbeavailablelater. 1. Secure the back plate to the mount bracket using 4 M3 x 8.0mm screws.
2. Route cables through a hole on the wall or through the bracket. Below are the definitions for these cables.
3. Mount the sensor device onto the bracket by sliding it from top down. 4. Secure the installation by driving a screw from the bottom of the back plate.
3.Login and Registration 3.1 Server Configuration 1)Network configuration: When the FT9361-R is started, proceed with network configuration. DHCP or Static IPs are applicable. Figure 4-1 Network Configuration 2)Server:The FT9361-R requires a connection to a VAST FaceManager server. Click on the Configuration button on the upper right of screen to configure a VAST Face Managerserver IP. (http://xxx.xxx.xxx.
3.2 Log in to the account 4) Login:On the first startup, credentials are required for a name and password. Figure 4-3 Login 3.3 Reboot Press the Reboot button and the machine will reboot.
3.4 Setting Long press the screen enter the Setting modevia Password that you set in server. 3.5 Reset Long press the screen, select "Reset", enter the password: Az123567!. Machine will reset to factory mode. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.