AI-103 IR Illuminator Installation Guide Rev. 1.
Revision History: Rev. 1.0: Initial release Rev. 1.1: Changed effective IR range. I Specifications Model Name AI-103 IR LED quantity 6 pcs IR light range 20 meters IR wavelength 850nm IR bean angle 60° IR light control.
English II Mounting & Cabling Preparing for installation: 1. Remove the IR illuminator from its package. 2. You should purchase power cords with adequate length. 3. A T20 hex wrench. Assemble the IR illuminator with the Support Bracket: Use the included hex wrench to slightly loosen the ball swivel to adjust the shooting angle.
Install the IR illuminator next to your network camera, e.g., IP8352. Orient its shooting angle by adjusting the ball swivel screw. Secure the illuminator by fastening screws through the holes on the base of the equipment stand.
English AC Power Connection Power lines are connected to a connection block. Use them to connect the power cords you separately purchased. Control Line Connection Disassemble the waterproof connector through which you will route your control lines to the IR illuminator. Rubber ring (A) Screw nut (B) Rubber seal (C) Seal plugs (D) Housing (E) Sealing nut (F) IP8352 GPIO Pinouts Digital output Ground 1 2 3 4 5 6 7 8 9 10 Blue Red Shown above is the network camera's General Purpose IO terminal block.
1. Open the rear cover using a flathead screwdriver (taking the IP8352 as an example). 2. Replace the seal plug on the rear cover with parts A & B from the waterproof connector. 3. Pass digital IO lines through F > E > C > A+B. Insert D into unused holes on C. 4. Connect DO lines to the GPIO terminal block (shown above). Secure the sealing nut (F) by tightening to the rear cover. 5. Close the rear cover. 6. Pass IO lines through the mounting bracket.
English IV IR Configuration To configure the IR-related settings in camera firmware: 1. Open a browser management session according to your QIG (Quick Installation Guide). 2. On the main page, enter Configuration > Advanced mode > Media > Image (General settings) > click on a tab at the lower screen to open Day/Night settings. 3. Select the checkbox in front of "Turn on external IR illuminator in night mode." Click Save to preserve your setting.
IP Sur veillance