Tabletop TV Stand Instruction Manual SKU: STAND-TV00J Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-tv00j GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
TOOLS NEEDED DO NOT EXCEED WEIGHT CAPACITY. Failure to do so may result in serious injury. 80lbs (36.3kg) Phillips Screwdriver ASSEMBLY STEPS STEP 1 Stick rubber feet (K) to bottom of tempered glass (C). Attach support column (D) to tempered glass (C) with plastic socket (E) in between and metal pad (F) underneath. Use bolt (I) to secure assembly. Tighten using allen wrench (W).
STEP 2 Attach TV plate (A) to support column (D) at desired height using bolts (G) and metal washers (H). Attach wire clips (J) to back of support column (D). Optional: TV plate (A) can be installed on wall. Wall mounting hardware not included. STEP 3 Mount monitor brackets (B) to the back of your TV using bolts (L, M, N, O, P, Q) and washers (R, S, T) according to the size of mounting holes on your television. Make sure monitor brackets are both in the correct orientation.
STEP 4 Mount monitor to TV plate (A) as shown in diagram. Tighten safety bolts on bottom of monitor brackets (B) using phillips head screwdriver. safety bolt Route cables through cable management clips (J) on back of stand.
STEP 5 If your TV is located near a wall as shown in Diagram 5a, then a steel wire from security wire kit (X) can be attached for added security. Attach the two ends of the steel wire to the top two holes on the back of your TV as shown in Diagram 5b. Attach the center loop to your wall according to wall type as shown in Diagram 5c, 5d, 5e. 5a 5b 5c OPTION A: Wood Wall Drill 1.75” (45mm) deep holes using a 5/32” (or 3.8mm) drill bit. Secure with screws and washers.
STEP 5 (Continued) 5d OPTION B: Concrete/Brick Wall Drill 2” (50mm) deep holes using a 5/16” (or 8mm) drill bit, and press anchors into holes. Secure with screws and washers.
Love your new VIVO setup and want to share? Tag us in your photo! @vivo_us LAST UPDATED: 03/06/2020 Open Monday - Friday 7:00am - 7:00pm CST, our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product. help@vivo-us.com AVG.