User Manual

ManualsBrandsVIVO ManualsElectronicsHeight Adjustable Pneumatic Extended Arm Dual Monitor Wall Mount Full Motion Articulating, Fits 2 Screens 17 to 27 inches, Black

Pneumatic Arm Dual Monitor Wall Mount

Scan the QR code with your mobile device or follow the link

for helpful videos and specifications related to this product.

Instruction Manual

https://vivo-us.com/products/mount-v002g

SKU: MOUNT-V002G

help@vivo-us.com www.vivo-us.com 309-278-5303

Chat live with an agent!

GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

Summary of content (8 pages)

PAGE 1
Pneumatic Arm Dual Monitor Wall Mount Instruction Manual SKU: MOUNT-V002G Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/mount-v002g GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.
PAGE 2
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
PAGE 3
ASSEMBLY STEPS STEP 1 OPTION A: Wood Wall Use a pencil to mark drilling location for wood beam and drill 2.2” deep holes using 3/16”bit. Use of a stud finder is recommended. Mount arm (A) to wall using screws (W-A) and washers (W-C). Do NOT use anchors (W-B) for wood beam installation. OPTION B: Concrete/Brick Wall For concrete or brick wall installation, use a pencil to mark drilling locations and drill 2/4” deep holes using a 3/8” bit.
PAGE 4
STEP 2 Press covers (B) into screw holes. STEP 3 Install screws (M-A) or (M-B) with washers (M-C) in top two holes of the monitor, leaving 3mm of space between the screw heads and the monitor. Tighten using the 5mm Allen Wrench (C). Hang monitor over top two slots of VESA plate, install two bottom screws, and then tighten top screws using Allen Wrench (C).
PAGE 5
STEP 4 Tighten the socket screw if the joints are making a popping sound. Adjust arm tension by turning screw with Allen wrench (C). Turn clockwise to reduce tension and turn counterclockwise to increase tension. The tension should be just enough to hold your monitor In place without lifting itself up. If needed, adjust bolts on the sides of the hinge behind the VESA plate to tighten or loosen the tilt angle. Tighten using the 5mm Allen Wrench (C).
PAGE 6
STEP 6 Insert cables and replace covers while making sure the cables have enough slack to allow enough free movement of the arm.
PAGE 7
Adjust as Desired 7
PAGE 8
Love your new VIVO setup and want to share? Tag us in your photo! @vivo_us LAST UPDATED: 03/05/2020 Open Monday - Friday 7:00am - 7:00pm CST, our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product. help@vivo-us.com AVG.