Instruction Manual

1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. It is recommended to install a 1/4 IPS threaded pipe, secured to a
structural member of the building (not included).Then install threaded
nipple (B). into receiver and tighten with wrench.
NOTE: Item must be supported independent of the junction box due
to hanging weight.
3. Remove collar loop (C) from chain (F) and secure to threaded receiver
attached to structural member by tightening locknut.
4. Install canopy (D) to collar loop (C) by securing with collar ring (E).
5. Determine desired overall length, and amount of chain (F) needed.
Shorten chain using chain pliers. (Keep extra chain)
6. Attach chain (F) to collar loop (C) and to fixture loop (G) using quick
links (H).
7. Thread fixture wire and ground wire through chain (F).
NOTE: When you reach the collar loop (C), ensure there is no tension
on the wires. Cut excess wires, being sure to leave about 12” to reach
the junction box.
8. Separate two sides of molded wire, and strip insulation on each 5/8".
9. Loosen collar ring (E) and let canopy (D) slip down chain (F) carefully.
Silva Grande Chandelier
Item # JN 5080
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
Chain Pliers
Slip Joint Pliers Measuring Tape Wire Cutters
Wire Strippers
NOTICE:
A
C
D
E
F
G
B
H
Bulbs not included
1/4 IPS Pipe (Not provided)
Diagram 1