VI NOTICE !xxxx0! 21837618-7 X0 GB.doc 1 02/03/06 Johnson Controls Inc.
GENERAL SAFETY PRECAUTIONS • Ensure you read the following instructions carefully. • Follow all the warnings and instructions shown on the products. The International Electrical Symbols used on the device and in this notice are explained in table 1 at the end of this document. • Disconnect the equipment from the wall socket before cleaning. Do not use cleaning fluids or aerosols. Use a slightly damp cloth for cleaning.
• Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
• IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Content 1- Description ........................................................................................................ 7 1-1 Probe..........................................................................................................................7 1-2 Probe supply ..............................................................................................................7 2- Use .................................................................................................................
1- Description 1-1 Probe Connector to vehicle VI synchro cable connector Mains adapter connector VDR mode LED Trigger Switch USB connector Power supply LED Active vehicle link LED communication LED 1-2 Probe supply The probe may be supplied by: - The vehicle via the vehicule connexion - The mains adapter only for software downloading and uploading 7
2- Use 2-1 Connection diagram To PC via probe Trigger To vehicle VI synchronization cable To mains USB cable 8
3- technical specifications 3-1 Equipment environment Mains adapter: Input: 100-240V AC 1A 50-60Hz Output: 12V DC 1.67A The removable plug for the mains power distribution board is used as a breaker device for the mains power source. Mains adapter is only used for software downloading and uploading VI Probe: Input: 6-16V DC Pmax 10W .
4- Maintenance Any operation other than replacement of the battery must be carried out by an after sales service technician who is qualified to do so and knows the risks involved 5- Cleaning Disconnect the power before any cleaning operation. Use a damp cloth. Do not use solvents.
8- International electrical symbols DC (Direct current) AC (Alternating current) AC or DC Earth ground Warning, refer to the notice for information Warning against electrical choc Double insulated 7- After sales service In the event of any problems, please contact your Johnson Controls Inc. representative. Johnson Controls Inc. Service après-vente 1, Avenue Pierre-Gilles de Gennes Z.I. des Ajeux 72400 La Ferté-Bernard France Tel.