User's Manual

D-303486 KF-235 PG2 Installation Instructions 1
KF-235 PG2
Wireless PowerG 2-Way Keyfob
User's Guide
1. INTRODUCTION
KF-235 PG2 is a PowerG two-way 4-button keyfob, designed for use
with the PowerMaster family of control panels.
KF-235 features include arming and disarming of the system as well as
viewing status of system and operating a predefined programmable
function. Commands are invoked by pressing any of the four command
buttons. Status is indicated via the Status LEDs and buzzer after every
command.
KP-235 PG2 alerts both control panel and user when its battery is
depleted and needs to be replaced.
Figure 1: External View
A. ARM "AWAY" /
ARM "LATCHKEY"
B. ARM "HOME"
C. DISARM
D. AUX
E. Transmission LED
F. Status LEDs
2. INSTALLATION
2.1 Enrollment
Refer to the PowerMaster panel's Installer Guide and follow the procedure under the "02:ZONES/DEVICES" option of the Installer Menu.
A general description of the procedure is provided in the following flow chart.
Step 1 Step 2 Step 3 Step 4 Step 5
Enter the Installer menu
and select
“02:ZONES/DEVICES”
Select "ADD NEW
DEVICE"
See Note 1
Enroll the keyfob by
holding the
button
and release it as soon as
the yellow LED lights.
Alternatively, enter the
device ID (printed on the
back of the keyfob)
Select the desired Keyfob Number for the new
keyfob
Enter PARTITIONS.
See Note 2



 
Step 6 Step 7
Assign partitions to the
keyfob by pressing the
, and
buttons on the
panel
Select the "Device
Settings" option and refer
to section to configure the
keyfob parameter (AUX).


 means scroll and select
Notes:
1. If the keyfob is already enrolled, you can configure the keyfob parameter and assign partitions via the “Modify Devices” option – see Step 2.
2. PARTITIONS will appear only if PARTITIONING was previously enabled in the panel (for further details, see "Partitioning" in the PowerMaster
Installer Guide).
2.2 Configuring the Keyfob Parameters
Enter the menu and follow the configuration instructions for the KF-235 PG2 keyfob as described in the following table.
Option Configuration Instructions
Here you select the function of the AUX button on the keyfob device.
Options: Arm instant (default); Not Used; Status, Stop Beeps, Skip exit delay, and PGM.
Not Used: No function assigned to the AUX button.
Status:
Control panel displays and announces* the system status.
Stop Beeps:
Pressing the AUX button will cause the control panel and other devices in the system (such as keyfobs,
DEVICE SETTINGS
F02:P1 P2 P3
F02:PARTITIONS
MODIFY DEVICES
AUX A
DEVICE SETTINGS
ID No. 301-XXXX F02:Keyfob
ENTR ID:XXX-XXXX
ENROLL NOW or ADD NEW DEVICES 02.ZONES/DEVICES