SP-1200P POWERED SPEAKERS OWNERS MANUAL www.visionaudiovisual.
DECLARATION OF CONFORMITY Where applicable Vision products are certified and comply with all known local regulations to a „CB Certification‟ standard. Vision commits to ensure all products are fully compliant with all applicable certification standards for sale in the EU and other participating countries. The product described in this owner manual is in compliance with RoHS (EU directive 2002/95/EC), and WEEE (EU directive 2002/96/EC) standards.
USE ONLY DOMESTIC AC OUTLETS Connecting the unit to an outlet supplying a higher voltage may create a fire hazard. HANDLE THE POWER CORD WITH CARE Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself. Pulling the cord may damage it. If you do not intend to use your unit for any considerable length of time, unplug the unit. Do not place furniture or other heavy objects on the cord, and try to avoid dropping heavy objects on it. Do not tie a knot in the power cord.
FRONT PANELS Active Loudspeaker Slave Loudspeaker Volume Dial Long push to turn on/off Short push to switch input IR receiver REMOTE CONTROL 1. 2. 3. 4. 5. Power Input Select Volume Mute Tone Control 4 1 5 2 3 NOTE: When power is turned on the last volume setting and input will resume.
INSTALLATION 1. FIT BRACKETS TO WALL Position brackets over load-bearing studs and use appropriate screws to fix brackets. Ensure they are plumb. NOTE: Do not position the top of bracket closer than 90mm to ceiling. 2. TERMINATE CABLES TO MOUNTS Slave loudspeaker bracket: Input from master loudspeaker Use unshielded speaker cable provided. If cable provided is not long enough use unshielded speaker cable with gauge of 0.75mm or higher.
3. FIT LOUDSPEAKERS TO MOUNTS Fit loudspeakers to brackets from above. They click into place and cannot be removed. 90mm OPERATION 1. TURN ON AND OFF Long press on volume dial 2.
TO REMOVE LOUDSPEAKER 1. Squeeze the two tabs together at top/rear of loudspeakers. 2. Lift loudspeaker up and off.
TROUBLESHOOTING If your system is not operating properly, please refer to the following information. If the problem persists, disconnect from power and contact your AV reseller immediately. Problem Correction No power light Rotate volume control clock-wise. Check power source and power input cable. Check fuse in power cable plug. Power light on but no sound Turn the volume dial on the master loudspeaker up.
SPECIFICATIONS PRODUCT DIMENSIONS: 150 x 145 x 220 mm (length x width x height for each speaker) PRODUCT WEIGHT: 3.8 kg (per pair) CONSTRUCTION MATERIAL: MDF COLOUR: White TECHNICAL DETAILS: Amplifier Output: 2 x 15w watts (RMS) Woofer: 4″ Tweeter: 1.5″ Silk Input / Output Terminals: Phoenix connectors Output Impedance: 4 ohms Sensitivity: 85dB (1w/1m) Frequency response: 80Hz-16kHz POWER SUPPLY: 100/240v 50/60Hz AC External Power Supply – integrated transformer/plug type. DC Output 5V 2A, DC Cable 1.8m.
WARRANTY This product comes with a 2-year return to base warranty, effective from the date of purchase. This warranty applies only to the original purchaser and is not transferable. For the avoidance of doubt, this will be taken from the information held by the appointed national distributor at the point of sale. If the product is DOA (dead on arrival), you have 21 days from purchase date to notify the national distributor via your AV reseller.
