Installation & Operation Manual ZD2105IN-5 ZD2105MY-5 ZD2105EU-5 ZD2105RU-5 ZD2105US-5 ZD2105IL-5 ZD2105KR-5 ZD2105HK-5 ZD2105JP-5 ZD2105BR-5 Recessed Door/ Window Sensor ZD 2105-5 V0 1031205 6B1Z-21003
Introduction Thanks for choosing the Vision’s wireless door/window sensor of the home security device. This sensor is a Z-Wave™ enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave™ enabled network and it’s security framework.
1. Use a flat head screw driver to access the ZD2105 to change tops or access the battery. (See figure 1). Note: All user and network settings will be cleared and the device reset to factory defaults when the device is excluded. 6. Put back the cover, the LED should go off. 7. Locate the Magnet close to the ZD2105 sensor, the distance between these two devices should be in 1.9cm. 2. Use care when installing the battery and observe the correct polarity, when the battery is inserted (see Figure 2). 3.
Federal Communications Commission Statement This equipment has been followed to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.