User's Manual

Federal Communications Commission Statement

This equipment has been followed to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try and

correct the interferene by one of the following measures:

Reorient or relocate the receiving antenna,

Increase the separation between the equipment and receiver,

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undersired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

Limited Warranty

Vision Guarantees that every wireless lighting module is free from physical defects in

material and workmanship under normal use for one year from the date of purchase. If the

product proves defective during this one-year warranty period, Vision will replace it free of

charge. Vision does not issue any refunds. This warranty is extended to the original end

user purchase only and is not transferable. This warranty does not apply to : (1) damage

to units caused by accident, dropping or abuse in handling, or any negligent use; (2) units

which have been subject to unauthorized repair, taken apart, or otherwise modified; (3)

units not used in accordance with instruction; (4) damages exceeding the cost of the

product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.

For information on addional devices, plesae visit us at

www.visionsecurity.com.tw

-3-

Operation Manual

2GIG-Z-BRG1-433

Z-Wave Bridge – 433MHz

2GIG-Z-BRG1-

433

1011218

PAGE 1
Federal Communications Commission Statement This equipment has been followed to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
PAGE 2
™ Introduction Thanks for choosing the Vision’s CT Clamp Bridge of the home automation device. This module is a Z-WaveTM enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-WaveTM enabled network. Every main powered Z-WaveTM enabled device acts as a signal repeater and multiple devices result in more possible transmission routes which helps eliminate “RF dead-sport”.
PAGE 3
Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Industry Canada Caution This device complies with Industry Canada licence-exempt RSS standard(s).