Bathroom Corner Cabinet WF291467AAE / WF291467AAL Assembly Instructions - Please keep for future reference WF291467AAK Dimensions Width - 23.6inch Depth - 12.7inch Height - 31.
! Safety and Care Advice 1 Important – Please read these instructions fully before starting assembly • During assembly do not stand • Check you have all the components and tools listed on or put weight on the product, this could cause damage. the following pages.
Components - Fittings Please check you have all the panels listed below Note:The quantitie below are the correcet amount to complete the assembly. In some cases more fittin may be supplied than are required. A B C Male Camlock x 23 Female Camlock x 23 Dowel x 14 D E F Shelf Support Pin x 8 6*50mm Screw x 4 G H 3.
Using Camlocks Step 1 Connect the male camlock as diected in the assembly instructions using a scewdriver . 1 Step 2 DO NOT OVER TIGHTEN. NE PAS SERRER EXCESSIVEMENT. 2 Push the male camlock into the entry hole. 4 Step 3 3 Step 4 Insert the femle camlock as shown in the instruction. Turn the female camlock clockwise with a screwdriver . Note:ensure that the arrow on the top of the camlock points towards the entry hole for the male camlock .
Assembly Instructions 9 1 8 2 10 7 5 10 6 4 12 11 3
Assembly Instructions Step 1 A A A A A A 4 3 A A A A A A Step 2 C C A 8 C C C A A 7 C C C
Assembly Instructions Step 3 A A A 9 A A C C A 6 A C C C A 2 C 5 Step 4 K K K K J1 J1 1
Assembly Instructions Step 5 L L 1 2 Step 6 1 2 B B 4 B 2 B B B 5 3 3
Assembly Instructions Step 7 8 7 6 E E E E F F Step 8 1 B 8 B B 7 2 3
Assembly Instructions Step 9 1 2 3 2 3 B 6 5 B 4 B 4 B 7 8 B 8 B 2 B B 3 Step 10 1 9 B B B B B 8 B 7
Assembly Instructions Step 11 1 N N 2 N N N N N N N N N N N N N N N Step 12 D D D D D D D D D 3
Assembly Instructions Step 13 D 10 10 D Step 14 H H I H J2 12 G H H G H H H H G H J2 H I H G H I 11 H H H H J2 H I H I H H H H H H H
Assembly Instructions Step 15 H H 11 3 H H I H 11 H 3 Step 16 H H 4 12 H H 11 I H H 4 12
Assembly Instructions Step 17 The unit is floor standing, but it is recommended that the unit is secured to the wall. 1. Move the unit into desired position. 2. Mark the wall with a suitable scribe the position of the fixing holes. Warning: ! M M Before driling,check wall for hidden pipes and cables. 3. Drill holes and insert 2 x wall plug 4. Attach 2 x Wall Straps to to the top of the unit using 2 x Washers and 2 x Screws 5.
Assembly Instructions Step 19 Assembly is complete.