Installation 3 Series Built-In Electric Warming Drawer RVEWD330/CRVEWD330
Table of Contents Warnings & Important Safety Instructions _______________________________________________3 Dimensions _________________________________________________________________________4 Specifications _______________________________________________________________________5 Cutout Dimensions __________________________________________________________________6 Electrical Requirements ______________________________________________________________7 General Information_____________________________________
IMPORTANT– Read and Follow! • Before beginning, please read these instructions completely and carefully. • The installer must leave these instructions with the consumer who should retain for local inspector’s use and for future reference. Your safety and the safety of others is very important. In Canada: Installation must be in accordance with the current CSA C22.1 Canadian Electrical Codes Part 1 and/or local codes. We have provided many important safety messages in this manual and on your appliance.
Dimensions 1 (25 0” .4 cm ) 8-3 (221/3 .4 2” cm ) 29 (74-1/2 .9 ” cm ) 4” -1/cm) 3 2 .1 (59 ” /16) 7 m 7 c 2 9.7 6 ( 27-7/16” (69.7 cm) 22-15/16” (58.3 cm) 1-5/8” (4.1 cm) 23-7/16” (59.
Dimensions Rear View 27-7/8” (70.8 cm) 8-31/32” (22.8 cm) 120V Electrical Opening (When facing cabinet, opening is located on right side.) 2” (5.1 cm) 2” (5.1 cm) Specifications Description RVEWD/CRVEWD Overall width 29-1/2” (74.9 cm) Overall height (from bottom) 10” (25.4 cm) Overall depth (from rear) To end of handle 27-7/16” (69.7 cm) 48” (121.9 cm) With drawer fully extended Interior width Interior height Interior depth Electrical Requirements Max. Amp Usage Approx. shipping wt.
Cutout Dimensions Indoor RVEWD/CRVEWD C A B Cutout width (A) 28-1/4” (71.8 cm) Cutout depth (B) Cutout height (C) 23-1/2” (59.7 cm) 9-1/4” (23.5 cm) Flush Mount Option: Note: To install the warming drawer in a flush mount application, a flush mount accessory kit is required and sold separately. RVEWD/CRVEWD Cutout width (A) 29-5/8” (75.3 cm) Cutout depth (B) Cutout height (C) 25-1/8” (63.8 cm) 10-1/8” (25.
Electrical Requirements Electrical Requirements WARNING Check your national and local codes regarding this unit. Hard wire direct with seperate 120V/15 amp minimum 2-wire wtih ground circuit. Maximum amp usage. ELECTRICAL SHOCK HAZARD To avoid the risk of electrical shock, personal injury or death; verify electrical power is turned off at the breaker box until the range is installed and ready to operate, installation by an authorized installer only. RVEWD/CRVEWD Max. amp usage 450 watts 3.
General Information READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE. • When installing this unit directly below other units, only install with Viking builtin products. • Remove warming drawer carefully from carton. Remove all loose packaging and accessories. Moving, Handling and Unpacking Remove and discard all packing materials, including cardboard and tape on the outside and inside of the warming drawer.
Installation 2 1 2 1 Pull out warming drawer pan until fully extended. Slide finger along right and left side until you reach the black hand latches (located at the front of the rails). Pull up on both the right and left latches and pull out drawer pan support. Electrical opening (from rear) 3 4 2” (5.1 cm) 2” (5.1 cm) 2 1 1 Remove strain relief bracket and mounting screws on the terminals. Feed supply cord up through hole in rear of warming drawer.
Installation (cont.) 8 7 x4 Slide cavity assembly into the cabinet opening. Secure the warming drawer using four #8 mounting screws (four screws provided). 9 Replace drawer assembly. Final Preparation • All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material.
Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range, LLC, 1-888-845-4641 for the nearest service parts distributor in your area or write to: VIKING RANGE, LLC PREFERRED SERVICE 111 Front Street Greenwood, Mississippi 38930 USA Warming Drawer – The serial number and model number for your appliance can be found by pulling drawer out until it stops and lifting inner lining.
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or visit our website at vikingrange.com in the US or brigade.
