Specifications

FRONT
VEWD
FRONT
DEWD
FRONT
DFWD
REAR
2”
(5.1 cm)
2” (5.1 cm)
10”
(25.4 cm)
B
10”
(25.4 cm)
B
B
C
8 31/32”
(22.8 cm)
(When facing cabinet, opening is
located on right side.)
MODEL VEWD173 DFWD171 VEWD103 DFWD101 VEWD163
VEWD173T VEWD103T VEWD163T
DEWD173 DEWD103
B 26 1/2” 26” 29 1/2” 29” 35 1/4”
(67.3 cm) (66.0 cm) (74.9 cm) (73.7 cm) (89.5 cm)
C 24 7/8” 24 7/8” 27 7/8” 27 7/8” 33 5/8”
(63.2 cm) (63.2 cm) (70.8 cm) (70.8 cm) (85.4 cm)
120V Electrical opening
5
10 1/2”
(26.7 cm)
3/4” thick
4
CABINET INSTALLATION
•To remove drawer assembly, pull warming drawer pan out until fully extended. Slide finger along the right and left
side until you reach the black hand latches (located at the front of the rails). Pull up on both the right and left latches
and pull drawer pan support completely out.
•For outdoor models ONLY - Apply silicon caulk that is provided all around the back of the warming drawer trim.
•Slide cavity assembly into cabinet opening.
•Drill (4) pilot holes in cabinet using 1/8” drill bit. Permanently secure the warming drawer using the (4) #8 mounting
screws provided.
•Replace drawer assembly.
CUSTOM FRONT INSTALLATION - DFWD MODELS
•Open the drawer and remove the pan.
•Center the custom front on the inside panel.
•Attach the custom front with the (6) six #8 x 3/4” screws provided.
CABINET CUTOUT
DFWD MODELS
24”
(61.0 cm)
9 5/8”
(24.4 cm)
Cabinet
Model DFWD171 DFWD101
25 1/4” 28 1/4”
A (64.1 cm) (71.8 cm)
Cavity Assy.
Mounting Screws
(4) - #8 x 3/4”
(2 per side)
(6) - #8 x 3/4” screws to
attach custom front
custom front
Identification
Label
Location
www.dexpress.com Page 75 of 76 6/25/2009
www.dexpress.com Page 75 of 76 6/25/2009
VEWD103SS
VEWD103SS
Cond Inst
Cond Inst