Installation Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Website at vikingrange.
Table of Contents Warnings & Important Information _____________________________________________________3 Designer Dimensions ______________________________________________________________________________6 Specifications ____________________________________________________________________________7 Proper Disposal (of old refrigerator) ____________________________________________________8 General Information__________________________________________________________________9 Remove the Packaging _____________
Refrigerator Safety IMPORTANT– Please Read and Follow A GFI shall be used if required by NFPA70 (National Electric Code), federal/state/local laws, or local ordinances. • The required use of a GFI is normally related to the location of a receptacle with respect to any significant sources of water or moisture. • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the requirements below.
Dimensions Specifications D3 French Door Bottom-Mount Description RDFN536 Overall width 35-5/8” (90.5 cm) Overall height To top of door: 70-1/8” (178.1 cm) To top of cabinet: 68-5/8” (174.3 cm) Overall depth from rear 34 (87-3/8 .3 ” cm ) 70 ” 7/8 (17 -1/8 8.1 ” cm (83 ) (8 68 (17 -5/8 4.3 ” cm ) 7 (2. /8” 2c m) 24 Cutout width 36” (91.4 cm) Cutout depth 29” (73.7 cm) Inlet water requirements 3 .8 9 (63-7/8 .2 ” cm ) Back of refrigerator - 68-7/8" (174.
Proper Disposal (of old refrigerator) IMPORTANT: General Information Clean Before Using Your refrigerator was packed carefully for shipment. Remove and discard all packaging and tape. DO NOT remove the model/serial number label. Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous - even if they will sit for “just a few days.” If you are getting rid of your old refrigerator, please follow these instructions to help avoid accidents.
General Information Electrical Requirements To ensure proper ventilation for your refrigerator, allow for a 1/2" (1.25 cm) space on each side and at the top. Allow 1" (2.5 cm) of space behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave a 3-3/4" (9.5 cm) minimum space between the refrigerator and wall to allow the door to swing open.
Doors & Drawer Removal Door & Drawer Removal Remove and Replace Handles Replace Doors and Hinges Remove Doors and Hinges (cont.) 6. Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the left-hand side door from the bottom hinge pin. 1. Using a 3/32” or 1/8” hex wrench, loosen the two set screws located on the side of each handle. 2. Pull the handle straight out from the door. Make sure you keep the screws for reattaching the handles. 3.
Installation Installation Water Supply Requirements Connect the Water Supply Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFF. TOOLS NEEDED: • Flat-blade screwdriver • 7/16" and 1/2" Open-end or two adjustable wrenches • 1/4" Nut driver • 1/4" Drill bit • Cordless drill Connect to Water Line 1.
Leveling/Adjusting the Door To enhance the appearance and maintain performance, the refrigerator should be level. To protect property and refrigerator from damage, observe the following: • Protect vinyl or other flooring with cardboard, rugs, or other protective material. • DO NOT use power tools when performing leveling procedure.
Performance Checklist Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W Greenwood, Mississippi 38930 USA The serial and model numbers for your refrigerator are located on the upper wall, behind the lighting.
