Use & Care Manual Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com in the US or brigade.ca in Canada F20733B EN 17-3336-02 15”W.
CONGRATULATIONS TABLE OF CONTENTS Congratulations and welcome to the elite world of appliance ownership. We hope you will enjoy and appreciate the care and attention we have put into every detail of your new, state-of-the-art ice machine.
IMPORTANT – PLEASE READ AND FOLLOW INITIAL START UP • Before beginning, please read these instructions completely and carefully. • DO NOT remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. • Please observe all local and national codes and ordinances. • Please ensure that this product is properly grounded. • The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future reference. 1.
USE (cont.) WATER QUALITY Never keep anything in the ice storage bin that is not ice. Objects like wine or beer bottles are not only unsanitary, but the labels can slip off and plug up the drain. All water, including potable water supplied by municipalities, contains some impurities or minerals. Water absorbs impurities from the air as rain and/or as it flows through the ground. Some of the impurities are solid particles, these are known as suspended solids, and a fine particle filter will remove them.
MAINTENANCE CARE AND CLEANING There are 5 things to keep clean: 1. The outside cabinet & door. 2. The ice storage bin. 3. The condenser. 4. The ice making system. 5. The ice scoop. Condenser cleaning The condenser is like the radiator on a car, it has fins and tubes that can become clogged with dirt and lint. To clean: 1. Remove the kickplate and front service panel. 2. Locate the condenser surface. How to clean the cabinet Wipe off any spills on the surface of the door and handle as they occur.
CARE AND CLEANING (cont.) 4. Drain the water reservoir by removing the rubber cap under the reservoir - it's near the back wall of the ice storage bin. CARE AND CLEANING (cont.) 4. Pour 8 ounces of Ice Machine Scale Remover into the ice machine reservoir. Pour scale remover here Rubber cap 5. Disconnect the incoming water line at the inlet water valve. 6. Open the door, push and release the on/off switch to turn the machine on. 7. Blow air through the inlet water valve; a tire pump could do the job. 8.
TROUBLESHOOTING GUIDE FGIM/FPIM UNDERCOUNTER/FREESTANDING ICE MACHINE WARRANTY PROBLEM CORRECTION Ice cubes are incompletely formed • Clean the ice making system. Low capacity • Check for restricted drain or standing water in the bin. • Clean the air cooled condenser fins. No ice “Time to Clean” light is on • Check On/Off switch. • Check electrical breaker. • If the “Check Water” light is flashing blue, check water supply. The control system checks for water every 20 minutes.
Notes Notes _____________________________________________________________________________________________________ _____________________________________________________________________________________________________ _____________________________________________________________________________________________________ _____________________________________________________________________________________________________ ______________________________________________________________________________________
