Installation manual

Doorphone Adjustments and Programming
Page 6 TYPE 115
In certain noisy locations (traffic or wind), the microphone volume may need to be decreased. A symptom
of this is one-way talk path, in which the distant party cannot be heard over the speaker. A “MIC VOL”
adjustment is provided on the doorphone for increasing or decreasing the microphone volume.
Microphone Volume
The “SPKR VOL” pot can be adjusted to increase or decrease the speaker volume to the desired level.
Speaker Volume
The “maximum number of rings can be adjusted using the DIP switches.
Maximum Number of Rings
Sw 1 Sw 2 Max Rings
OFF OFF 2
ON OFF 3
OFF ON 10
ON ON 30
1 Disconnect the PHONE LINE INPUT.
2 Slide the TALK BATTERY switch to the ON position.
3 Move DIP SWITCH 2 from OFF to ON.
4 Connect a phone to terminals 4 & 5 - LINE OUT TO PHONES.
5 Pick up the phone (you will hear a double beep - indicating that you have accessed the PROGRAMMING MODE).
6 You can now Touch Tone program the features listed below
Access Programming Mode (Local Access)
Step Action
1 Make sure C-1000B is in Programmin Mode - See above
2 Program Strike 1 activation time as follows:
3 Enter time (seconds) followed by #01
4 Program Strike 2 activation time as follows:
5 Enter time (seconds) followed by #02
EXAMPLE: 05#01 programs Strike 1 for 5 seoncds
03#02 programs Strike 2 for 3 seconds
Program Gate Strike Relays
Step Action
NOTE: Entering a time “00” sets time = 1/2 second Maximum time through programming = 9 seconds