Specifications

ManualsBrandsViewSonic ManualsDVD PlayerVT1901LED

SPECIFICATIONS

• As built weight calculations to be supplied with bid showing proposed vehicle, front

axle, rear axle, and total weight.

• Electrical load calculations showing power draw for all installed 120/240VAC and

12VDC systems to be supplied with bid.

• HVAC calculation showing proper heating and cooling based on occupants, equipment,

square footage, vehicle construction, windows, doors etc.

• Overall length of apparatus, including rear step and mast: 40ft Max.

• Overall height of apparatus (loaded): 12ft 6inch Max.

• Interior walkway height: 6ft 8inch Min.

CHASSIS:

2015 Freightliner MT-55 or approved equal, forward control chassis. 26,000-lb GVWR

Air Ride Suspension Hydraulic Brakes

Cummins ISB 6.7 260HP Engine or approved equal, - Allison 2200 EVS Transmission or

approved equal,

• Allison 2200 EVS automatic transmission or approved equal, with park pawl with PTO

provision

• Water to oil transmission cooler

• 10,000# single front axle

• Front oil seals

• Synthetic 75w-90 front axle lube

• TRW TAS-65 power steering

• 10,000# taperleaf front suspension

• Front shock absorbers

• Front stabilizer bar

• 17,500# Single rear axle

• 5.13 rear axle ratio

• Synthetic 75w-90w axles lube

• Rear oil seals

• Airliner or approved equal, 18,000# rear suspension

• Manual dump valve for air suspension with indicator light, without gauge

• Dual instant response rear suspension leveling valves

• Rear sway bar

• Rear shock absorbers

• Bosch or approved equal, hydraulic brake package

• Wabco or approved equal, hydraulic 4S/4M without traction control

Summary of content (19 pages)

PAGE 1
SPECIFICATIONS • As built weight calculations to be supplied with bid showing proposed vehicle, front axle, rear axle, and total weight. • Electrical load calculations showing power draw for all installed 120/240VAC and 12VDC systems to be supplied with bid. • HVAC calculation showing proper heating and cooling based on occupants, equipment, square footage, vehicle construction, windows, doors etc. • Overall length of apparatus, including rear step and mast: 40ft Max.
PAGE 2
• 60 gal / 227 liter rectangular steel fuel tank - between rails • Length of auxiliary pickup tubes (generators, furnaces etc.) shall prevent these devices from using more than 75% of vehicle's fuel tank capacity. • Michelin XZE 255/70R22.5 16ply front radial tires or approved equal • Michelin XDE M/S 255/70R22.5 16ply rear radial tires or approved equal • 22.5x8.25 10-hub pilot aluminum front wheels • 22.5x8.
PAGE 3
50" from ground. • Aluminum one piece extruded 6005-T5 alloy 3" x 3" wall beams on 24” centers, 0.125 wall thickness. Studs feature machined wire pass-throughs, and raised adhesive control features on base. • Beams shall be chemically bonded to sidewalls eliminating the need for rivets. Buckrivets will be used to fasten the top and bottom rub rail. Use of two-sided tape is not acceptable. • Body shall have 0.125" strain-hardened aluminum alloy 5052-H36 side panels.
PAGE 4
• Rear frame-mounted tow eyes extending past body. • Aluminum engine box cover with acoustical and thermal insulation. Black molded ABS composite engine box over-lay. • Acoustical and thermal insulation with heat shield on exterior fire-wall. • Full length skirting. Skirt shall extend 18” down from the bottom of floor extrusions. • Dash shall be vacuum formed ABS composite with integrated control pod located left of dash. • All clearance and side marker lights to be LED.
PAGE 5
• Cover cab doors with one piece aluminum panels. Upper half to be wrapped with vinyl and lower half to be wrapped with padded vinyl. • 10" high 0.100" bright aluminum tread plate kick plate at bottom of doors. • Heavy-duty rubber grab handle on each door. • Panels covered with vinyl above driver and passenger doors. • Vehicle height sign on dash. • Insulated black rubber mat in driver and passenger toe plate area. Insulate walls in toe plate area and install carpeted panels.
PAGE 6
30" pocket doors to separate each room and cab area. Cover pocket doors with silver smooth FRP and cap all sides with anodized extruded aluminum. All screws shall be stainless steel. Pocket doors shall be installed on heavy-duty aluminum tracks with two (2) four-wheel roller trucks. Pocket door shall have recessed handles and a key lock. All bulkheads shall be covered with Kemlite 0.075" silver smooth FRP. Cap all sides with anodized extruded aluminum. All screws shall be stainless steel.
PAGE 7
• Double stapling of fabric/vinyl to backer with industrial grade upholstery staples. CABINETS: All proposed cabinets shall be custom fabricated aluminum and built for the exact space it will be installed in. Cabinet specifications: • Base cabinets to be constructed of 0.080" powder coated aluminum with anodized aluminum frames. • Base cabinet doors shall be double shell, formed from a single sheet of 0.080" aluminum, with a 0.040" aluminum door back attached. • Overhead cabinets constructed of 0.
PAGE 8
ventilator. Fan-tastic roof vent rain cover. Three (3) Ducted Coleman Polar Mach 9200 series or approved equal, low profile air conditioners. • 13,500 nominal BTU air conditioner with condensate pump.
PAGE 9
• NEMA 4 plastic enclosure: 5.14"(H) x 4.00"(W) x 2.45"(D) • LED Visual verification of status A multiplex controlled power and data electronics system must be incorporated into a common touch screen with the ability to distribute and control strategic on board systems. It also simultaneously allows distribution of the information to multiple onboard control/monitoring stations.
PAGE 10
120/240VAC WIRING REQUIREMENTS: • All 120/240Vac main wiring shall be stranded THHN wire and run in non-metallic Carlon Carflex or approved equal, liquid tight conduit. • All electrical circuits and appliances shall conform to applicable national electrical codes. 12VDC ELECTRICAL SYSTEM: • Four (4) 6Vdc Absorbed Glass Mat (AGM) or approved equal, batteries. Batteries shall be installed underbody in slide out weather resistant compartment.
PAGE 11
approved equal. Two (2) Whelen TIR3 series or approved equal, Super-LED lighthead with internal flasher, red LED's with clear outer lens and chrome flange. Six (6) Whelen 600 series or approved equal, Linear Super-LED lighthead with internal flasher, red LED's with clear outer lens and chrome flange. Two (2) Whelen 600 series or approved equal, Linear Super-LED lighthead with internal flasher, 1/2 red, 1/2 amber LED's with clear outer lens and chrome flange.
PAGE 12
Two (2) ViewSonic VT3255LED - 32" Class LED-backlit LCD TV/Monitor or approved equal, with wall mount bracket. • HD-grade 1680(H) x 1050(V) pixel resolution • Component , Composite , HDMI , S-Video • VGA (HD-15) • Hidden bottom speakers • TV Tuner, NTSC • Dimensions: 29.6"(W) x 19.1"(H) x 2.
PAGE 13
Will-Burt or approved equal, 52-ft. heavy-duty non-locking telescoping pneumatic mast. Mast features: • 100 lb. payload capacity (including Nycoil) • 52' extended height • 8' 4" nested height Includes: • Airmaster Control with airline filter, lubricator, regulator, control valve and dump valve. • 80' of 3/4" Nycoil conduit and weather-tight fittings. • Will-Burt external mount shelf bracket and external mount support bracket. • Interlock to prevent vehicle from being driven with mast raised.
PAGE 14
• 12Vdc power routed to radio transceiver location. Install Firecom 5000D series or approved equal, digital intercom system. Located at each workstation • 5300D, digital intercom • MR-cable • HM-10 headset module • Cable 6c flat • Hanger hook for each headset Install ten (10) department supplied communications radios. These radios shall be tied to Firecom 5000D or approved equal, headsets. Installation includes: • NMO-style base on the roof or antenna raceway, as applicable.
PAGE 15
Install an aluminum shroud with weatherproof pass-through open/close hatch on the landline input box and paint to match body. 66-style punch-down block. Panasonic KX-TA824 or approved equal, Electronic Modular Switching System. Panasonic KX-TA82483 or approved equal, Expansion Card. Panasonic KX-TA82481 or approved equal, Expansion Card. Five (5) Panasonic KX-T7730-B or approved equal, black twelve-line speakerphone telephone with 16-digit alphanumeric LCD display.
PAGE 16
Three (3) IOGEAR GCS22U or approved equal, 2 port USB KVM switch • Built in cables • Remote switch button keeps the desktop clear of cables • USB keyboard and mouse support • Powered from USB bus so no external power supply is required • 3 year manufacturer warranty Seven (7) USB extender from rack mounted computers.
PAGE 17
Columbia Weather Systems Magellan™ weather station or approved equal, wall mounted LCD touch screen display. • All-In-One Sensor Transmitter housed in a Self-Aspirating Radiation Shield • Temperature Sensor • Relative Humidity Sensor • Digital Barometer • Relative humidity probe.
PAGE 18
Single door underbody storage compartment with interior dimensions of 15" high x 60" wide x 25" deep constructed from 0.125" aluminum with all welded seams and flip down door. Compartments will be constructed to the following specifications: • Sweep out type bottoms with 1/2” drain holes. • 2" box pan doors and door frames fabricated from 0.125" aluminum. • Door frames shall be riveted to the body and welded to the compartments. • Compartments shall have a LED light that illuminates when the door is opened.
PAGE 19
MANUALS: Custom operational manual for training vehicle operators on all aspects of proper storage, start-up procedures, and shut down procedures. Supply on paper and CD. Complete manual set on paper and CD, including the following: • As-built specifications with interior and exterior drawings as used for production of the vehicle. • Chassis and body owner's manuals. • 12Vdc and 120Vac legends showing wire gauge, color, number and function.