Quickstart Guide

Installation Instructions
Adapter Plate
ViewSonic Corporation
10 Pointe Drive
Brea, CA 92821
www.viewsonic.com
[phone]
Made in USA
Parts Included
Attach the Adapter Plate
Attaching to Promethean Arm
1
5- #10 Washers
4- 4mm x 12mm FHMS5- 4mm x 10mm PHMS
Attach Promethean Bracket
2
If Dome is not Centered
3
1. Place (4) spacers over the threaded inserts on
the bottom of the projector. Attach Adapter Plate to
Projector with (4) 4mm x 12mm FHMS
2. Attach Promethean Bracket to Adapter Plate with
(5) 4mm x 10mm PHMS & (5) Washers
3. If dome is not centered with lens on installation,
remove Dome from Promethean Bracket.
Attach the Adapter Plate
Attaching to Smart Arm
1
Screw in Adapter Plate
2
1. Place four spacers over the threaded inserts on
the bottom of the projector.
2. Place Adapter Plate onto the bottom of projector,
aligning mounting holes on bracket with threaded
inserts on the bottom of projector, and line up with
the center of the projector lens.
3. Attach Adapter Plate to Projector with (4) 4mm x 12mm FHMS
4. Lift Adapter Plate with projector up to end of the existing SMART Board projector mount arm, and slide
interface bracket slots onto hooks.
5. Fasten interface bracket to end of SMART Board projector arm using one 1/4-20 x 3/8" THMS
Bracket at end of
SMART Board projector
mount arm (remainder
of arm not shown)
WALL
1- 1/4-20 x 3/8" THMS
Adapter Plate
TOP VIEW
TOP VIEW
LENS
Align Dome to Len's Center
4
Lens is Centered
5
4. Replace Dome on next set of holes on the
Promethean Bracket
5. Dome is now directly over Projector Lens
4- 1/8" Spacers
Promethean Smart Board
4- #10 Washers1/4 Fender Washer Adapter Plate 4- 1/8" Spacer
1- 1/4-20 x 3/8" THMS
4- 4mm x 12mm FHMS