Wireless PannerOperating Instructions VT-9512RX FCC ID:2ABFHVT-9512RX Wireless Panner Specs 1. Distance:Up to 10 meters 2. Charging power: 5V/500mA 3. Power consumption: 0.2W 4. Battery: 3.7V/2200mA 5.
Diagram of features: A: Power button [on panner] B: LED light [on panner] C: Left control button: pans to the left [on remote] D: Right control button: pans to the VT-9512TX FCC ID:2ABFHVT-9512TX right [on remote] E: Charging port [on panner] Operation: Deploy the camera: Lower your camera to the desired depth, then position the cable in the u-shaped channel on the bottom of the panner. anchor the camera cable in place.
TROUBLE SHOOTING: 1. Pairing: Turn on the wireless panner, and quickly press the power button (A) 3 times in 3 seconds. Next, pressand hold either button(C or D) on the remoteuntilthe motor is rotating to left or right. This means that the pairing is OK,and the wireless panner can be controlled by this remote. 2. Using a new remote: If the remote is lost, you first must order a new remote.
battery. If the light is flickering in a pattern, the number of flickers indicates the battery strength out of a possible 4 levels. [Example: the light flickering in a repeating pattern of 2 indicates battery strength is 2 out of 4. 5. The LED lightflickeringvery quickly indicates the battery does not have sufficient power.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.