VICTROLA USB Turntable Model: PRO-3100 Instruction Manual PLEASE BEAD THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE AND REEF IT FOR FUTURE REFERENCE.
ASSEMBLY OF THE DUST COVER suwumwmmmanaaiaiimima sim TURNTABLE OPERATION civ easiness HOW TO REPLACE THE NEEDLE ism iF THE BELT BECOMES TIPS FOR BETTER TURNTABLE USE (iii sii moan USE RECORDING OPERATION domes CALIFORNIA PROP 85 WARNING covcavamimmiasianans fe Don pn ee SOE
SAFETY INSTRUCTIONS Read these instructions = All the safely and operating instructions should be read before this product is operated, Keep these instructions = The safety and operating instructions should be retained for future reference. Heed all wakings = All wakings on the appliance and in the operating instructions should be adhered to. 4. Follow all instructions All operating and use instructions should be followed. 5.
21.1 This equipment is a Class ll or double insulated electrical appliance, ] it has been designed in such a way that it does not require a safety connection to electrical earth.
Lara hie Van 0d 1 Turntable Platter 9 Tone Arm Return Button (Eject) 2 Tone Arm 10. TonsAmliiLever{m ¥) 3 45 RPM Adapter 11. Dust Cover Hinges 4. Tone Arm Lock 42. Dust Cover 5 Phonon Stylus Cartridge 43. USE Output Jack 6 Power Button 14, Power Adapter Jack 7. Speed Change Button 18. RCA Output Jack, 4.
ASSEMBLY OF THE DUST COVER 1: Remove protective plastic film from the DUST COVER. 2 Align the DUST COVER (#12) to the DUST COVER HINGES on the back of the unit. Then, push down the dust cover gently {o clip into the hinges. TURNTABLE OPERATION SET UP An AC/DC adapter with an output of is included with the LIB Turntable. This adapter is required Tor operating the unit; 1 Connect the external HEEL-Fl Amplifier or Speaker System using RCA Cables (Not included).
AUTO TUBE BESET It is recommended to reset the Auto Return when you move this product The mechanism of Auto Return will rotate irregularly when moving and it will cause the malfunction of Auto Return. The following steps will reset the Auto Return, 1: Place a record on the platter and play it (Follow the Operation Steps above). 2. Manually place the Tone Arm to the blank part at the end of the record and let i finish playing. 2.
IF THE BELT BECOMES LOOSE The belt and imitable platter have been installed properly during production, but the belt may have become loose during transportation. if so, follow the below procedures to re install the belt drive. 1. Remove the rubber mat from the turntable platter and carefully uncle the small E ring from the turntable shaft (Using tweezers or pliers), Then release the turntable platter from the shaft. 2.
REE This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation, Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
To obtain service, the purchaser MUST present an original sales receipt / proof of purchase, Please contact us at www electrolytic to request an RMA (Return Material Authorization) number to return products for service or replacement. Returns without an BMA number on the package will be refused and returned to sender. Upon receipt of the returning item ang our full inspection (IT) may issue a replacement to customer Tor the same item or of one that has equivalent value and features.