BEBT-T-4T er:bl that'd 28d Wl ~ \ NOTICES TO THE USER The radios operate on Family Radio Service (FRS) designated frequencies. FCC has established the license free, short range two way radio service for family and individual recreational use anywhere in the United States & thee areas sifted by the FCC.
AERIE Ere == NW ~SELECTING. A CHANNEL Selecting Chord [Corps Un ve To hrs catatonic SPE YOu Oe Wang ho Folk 0 re 5 E51 100 WO 0 (DCO i When your The some channel, fey Location oF Controls OPERATING INSTRUCTIONS .. INSTALLING THE BATTERIES... Using THE BELT Hook Basic Operations .. MONITOR ..overmanned OPTIONAL ACCESSORIES FREQUENCY CHART .
Headphone Jack External Microphone Jack Power On/low Battery Indicator Channel A India Button Monitor On/Off Power On/Off Button Button Push To Talk Volume Down Button Button Channel Selector “Belt Clip Button Microphone Battery Compartment ND Removing Batteries The transceiver requires 3 “AA” batteries. Use high quality alkaline batteries to enjoy longer periods of battery fife.
eee ee Err THE BELT Err Basic Operations 1.To remove clip turn screw counterclockwise until you can 1. Press the POWER switch for more remove clip. than 1 second to tum the transceiver power ON. The Power On Indicator will flash every 2 ) seconds, ) 2. Align the screw and the clip with the screw hole and turn 2. Press the VOLUME UP button to clockwise to attach clip, Do not over tighten the screw. increase the volume or Press tr a the VOLUME DOWN to decrease the volume.
3. Press and hood the Channel button for one second to 5. Release the PTT switch to select between the per-programmed channels (A or B). receive. The appropriate indicator will light up. * You must select the same channel as your group members have selected. Ch.| Freq. (Mhz) . When you receive a call, A | 467.5625 . you will hear audio from the speaker. 2 B | 467.6625 6. Repeat steps 4 and 5 to continue communication. 4.
ee 7. To turn the transceiver power OFF, 2. Press and half the Monitor key. press the POWER switch for more To deactivated the Monitor than 1 second. The Power function. indicator light will go out. Whiz Monitor function muteness the speaker in any situation. use this function when received signals are 100 weak to recognize or when you want 10 adjust the volume while listening to background noise. 1. Press and hold the Monitor key for approximately 1 second, the Monitor function is active.
Ch.| Freq. (Mhz) A | 467.5625 B | 467.6625 Troubleshooting GUIDE Check The Following Guide Far Problem Resolution, PROBLEM [POSSIBLE CAUSE | SOLUTION General No anon be Hens Power not On. Flows the POWER Boston for oon than one second Ky Jem on ars, Whine Contort is at mintage | Bet ihe Volume Concrete 00 Proper sound emt Hand phone pliant addend into | Remember Hand phone plug fom us Antiphons jack. the Headphone jack. Can nck races call Ash Fa Thoth bunion fs Massacre Foals To Tek bison. prosody.