250C-IG COMPRESSOR KIT 12V PART NO. 25050 250C-IG COMPRESSOR KIT 24V PART NO. 25058 IMPORTANT: It is essential that you and any other operator of this product read and understand the contents of this manual before installing and using this product.
50C-IG COMPRESSOR KIT IMPORTANT SAFETY INSTRUCTIONS CAUTION - To reduce risk of electrical shock or electrocution: - Do not disassemble. Do not attempt repairs or modifications. Refer to qualified service agencies for all service and repairs. - Do not use this product in or area where it can fall or be pulled into water or other liquids. - Do not reach for this product if it has fallen into liquid. - Use this compressor with 12-volt (P/N 25050) or 24-volt (P/N 25058) DC systems only.
250C-IG COMPRESSOR KIT MOUNTING AND WIRING 1. Disconnect ground cable from vehicle’s battery. 2. Temporarily position the air compressor in the location where it will be mounted. 3. Route ground wire to the negative post of the battery or to an appropriate grounding point and cut ground wire to length as needed. 4. Mount air compressor with the four sets of bolts, nuts, washers, and locking washers provided. (See Mounting Instructions) Use of thread locker is recommended. 5.
250C-IG COMPRESSOR KIT OPERATING INSTRUCTIONS 1. IMPORTANT: Always operate the compressor at or below the MAXIMUM PRESSURE RATING of the compressor. Please refer to Application & Specifications Sections of this manual for details. 2. Always observe the MAXIMUM DUTY CYCLE of the air compressor. Refer to Compressor Applications and Specifications Sections of this manual for details. Operation exceeding maximum pressure ratings and/or duty cycle will result in damage to the air compressor. 3.
250C-IG COMPRESSOR KIT • Part No. 25058 / 250C-IG-24V Compressor Kit (CE Spec.) Motor Voltage: Max. Current Consumption: Motor Type: Horsepower: Max. Working Pressure: Max. Duty Cycle (@ 72°F & 100 PSI): Minutes On/Off (@ 72°F & 100 PSI): Max. Restart Pressure: Max. Ambient Temperature: Min. Ambient Temperature: Auto. Reset Thermal Protection: Dimensions: Net Weight: 24 Volts 5 Amps Permanent Magnetic 1/4 150 PSI 100% Continuous 150 PSI 158°F -40°F Yes 7.6”L x 4”W x 6.75H” 6.75 Lbs.
250C-IG COMPRESSOR KIT ABOUT RATED WORKING PRESSURE: To ensure trouble free service life of your compressor, always operate compressor within rated working pressure of the compressor. Never use a pressure switch with a higher cut-off pressure than compressor’s rated working pressure.
250C-IG COMPRESSOR KIT TROUBLESHOOTING GUIDE: Tank pressure drops when 1. Loose drain cock compressor (s) shut off 2. Check valve leaking 3. Loose connections 1. Tighten drain cock 2. Replace check valve or compressor(s) 3. Check all connections with soap and water solution and tighten Compressor runs continuously and air flow lower than normal 1. Excessive air usage 2. Loose connections 3. Worn piston ring or inlet valve. 4. Clogged air filter element 1. Decrease air usage 2.
250C-IG COMPRESSOR KIT VIAIR CORPORATION MANUFACTURER DEFECT WARRANTY: VIAIR Corporation warrants this product, when properly installed and/or under normal conditions of use, to be free from defects in workmanship and materials for a period of one year from provided date of purchase. To receive a warranty inspection, please contact VIAIR Corporation. A valid, dated sales receipt must accompany your request.