Technical Support and E-Warranty Certificate www.vevor.com/support Induction Hob User Manual MODEL:LI5-01 We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and doses not necessarily mean to cover all categories of tools offered by us.
Induction Hob MODEL:LI5-01 NEED HELP? CONTACT US! Have product questions? Need technical support? Please feel free to contact us: CustomerService@vevor.com This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
Warning-To reduce the risk of injury, user must read instructions manual carefully. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. This product is subject to the provision of European Directive 2012/19/EC.
CONTENTS BEFORE USE ....................................................................................................... 5 SAFETY INSTRUCTIONS .................................................................................. 6 INSTALLATION .....................................................................................................8 ELECTRICAL CONNECTION ............................................................................ 8 TEMPERATURE LEVEL TABLE ........................................
BEFORE USE IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol “INDUCTION SYSTEM” (Figure below) or enameled pots. Place the pot on the required cooking zone before switching the hob on. EXISTING POTS AND PANS Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not magnetically detectable. Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.
SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS ARE VERY IMPORTANT This manual and the appliance itself provide important safety messages, to be read and always observed. This is the warning / caution-safety symbol, regarding safety, warning of potential risks to users and other All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury, damage and electric shocks due to incorrect use of the appliance.
Do not touch the appliance heating elements during and after use. Do not allow the appliance to come into contact with cloths or other flammable materials until all the components have cooled sufficiently. Do not place flammable materials on or near the appliance. Overheated oils and fats catch fire easily. Pay attention when cooking food products rich in fat and oil.
INSTALLATION After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service. For built-in dimensions and installation instruction, see in below figures The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure (mini. 50mm). In order to ensure the correct operation of the product, do not obstruct the minimum required clearance (min. 20 mm) on the worktop for air flow out.
Installation must be carried out by qualified personnel who know the current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. The power cable must be long enough to remove the hob from the worktop. Make sure the voltage specified on the rating label located on the bottom of the appliance is the same as that of the home.
deactivated If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down. If no heating zone is selected within 120 seconds of switching on, the hob switches off automatically. Switching on and adjusting cooking zones Once the hob is switched on and the pan is positioned on the chosen cooking zone, select the zone using the corresponding button: the display shows level 0.
Timer The timer can be used to set cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all cooking zones. Select the cooking zone to be used with the timer, press the button with the clock symbol then set the desired cooking time using the buttons of the timer function (see figure). After a few seconds, the timer begins the countdown. Once the set time has elapsed, an acoustic signal sounds and the hob switches off automatically.
CONTROL PANEL WARNINGS Residual heat indicator The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot. If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to keep a dish warm or to melt butter. When the cooking zone cools down, the display goes off.
6-7 4-5 Medium level 3-4 2-3 1-2 Low level Power off 1 0/H Browning – cooking – stewing sautéing grilling Cooking – stewing sautéing grilling Cooking – simmering – thickening creaming Melting – defrosting – keeping – food warm creaming Support surface Ideal for sautéing, maintaining a light boil, cooking and grilling , preheating accessories Ideal for stewing, maintaining a gentle boil, cooking (for a long period of time).
TECHNICAL INFORMATION Voltage: 220 - 240V, 50/60 Hz Max. power: 9200W Top Left: 1800W BOOSTER 2000W Top Right: 1500W BOOSTER 1800W Middle: 2000W BOOSTER 2200W Down Left: 1500W BOOSTER 1800W Down Right: 1800W BOOSTER 2000W Only one zone can be use the function of “Boost“ at the same time per left or right side. CLEANING Do not use steam cleaners. Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”) is not displayed.
display, consult the following table for instructions. If the hob cannot be switched off after using it, disconnect it from the power supply.
AFTER-SALES SERVICE Before contacting the After-sales Service: 1. See if you can solve the problem yourself with the help of the “Troubleshooting guide”. 2. Switch the appliance off and then on again it to see if the problem has been eliminated. If the problem persists after the above checks, contact the nearest After-Sales Service.
Technical Support and E-Warranty Certificate www.vevor.